PISTON 3203619 - Caterpillar

Replace the engine oil filters when the following conditions are met:
Every oil change
The engine oil filter differential pressure reaches 100 kPa (15 psi).
The oil filters have been used for 1000 service hours or six months.Note: Do not attempt to clean the used oil filters. Used oil filters will retain waste particles. The used oil filters would not filter the oil properly.Service tools are available to aid in the service of oil filters. Consult your Caterpillar dealer for the part names and the part numbers. Follow the instructions that are supplied with the service tools. If the service tools are not used, perform the following appropriate procedure.Replacing the Engine Oil Filters With the Engine Stopped
Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Perform the following procedure after the oil has been drained.Note: Use this procedure if the engine oil filters do not have a control valve.
Illustration 1 g00296711
(1) Pressure gauge
(2) Drain
(3) Cover
(4) Control valve
Connect a hose from each drain valve (2) to a suitable container in order to catch the oil.
Open both drain valves (2). Allow the oil to drain. Note: Some oil will remain in the housing after the oil has been drained. This oil will pour out of the housing when cover (3) is removed. Prepare to catch the oil in a suitable container. Clean up any spilled oil with rags. DO NOT use absorbent particles to clean up the oil.
Personal injury can result from parts and/or covers under spring pressure.Spring force will be released when covers are removed.Be prepared to hold spring loaded covers as the bolts are loosened.
Be alert to the spring force. The cover has a spring force up to 240 N (54 lb). Gradually loosen but do not remove the last two bolts or nuts that are located at opposite ends of covers (3). Before removing the last two bolts or nuts, pry the covers loose or tap the covers with a rubber mallet in order to relieve any spring pressure.
Illustration 2 g00215989
(5) Wire rack
(6) O-ring seal
(7) Element
Elements (7) are mounted on wire racks (5) inside the housing. Use a pan to catch the oil that drips when wire racks (5) are removed. Remove wire racks (5). Remove used elements (7). Clean up any oil that is spilled.
Caterpillar oil filters are built to Caterpillar specifications. Use of an oil filter not recommended by Caterpillar could result in severe engine damage to the engine bearings, crankshaft, etc., as a result of the larger waste particles from unfiltered oil entering the engine lubricating system. Only use oil filters recommended by Caterpillar.
Ensure that the new oil filter elements are in good condition. Place the elements on wire rack (5). Install the wire rack and the elements.
Ensure that the surfaces for O-ring seals (6) are clean. Inspect the O-ring seals. If the old O-ring seals are damaged or deteriorated, replace the old O-ring seals with new O-ring seals. Install the O-ring seals.
Install covers (3). Ensure that the spring is seated properly