PISTON RING GROUP 3S4061 - Caterpillar

Introduction
The special instruction provides rework procedure for the 360-4091 Panel Harness As to the machines that are listed above.Do not perform any procedure in this Special Instruction until you have read this Special Instruction and understand this information.Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard.Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Avoid using a tool, a procedure, a work method, or operating technique that is not recommended by Caterpillar. If used, ensure the safety of the operating personnel and others.Ensure that the product will not be damaged or made unsafe by the operation, lubrication, maintenance, or the repair procedures that are used.
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Cat dealer for replacement manuals. Proper care is your responsibility.
Personal injury or death can result from improper assembly procedures.Do not attempt any assembly until you have read and understand the assembly instructions.
Accidental machine starting can cause injury or death to personnel working on the machine.To avoid accidental machine starting, turn the battery disconnect switch to the OFF position and remove the key. If the machine is not equipped with a battery disconnect switch, disconnect the battery cables from the battery and tape the battery clamps.Place a do not operate tag at the battery disconnect switch location to inform personnel that the machine is being worked on.
Rework Procedure for 793F, 795F Series AC, and 797F
Follow the below listed steps for performing the rework procedure of the 360-4091 Panel Harness As .
Table 1
Required Part    
Qty     Part Number     Description    
1     202-0313     Terminal As    
Illustration 1 g02757037
Illustration 2 g02713903
Illustration 3 g02760997
Disconnect the battery.Disconnecting the battery is necessary since work will be performed on 129-M143-RD-18 which is unswitched battery power.
Unplug the wire 129-M143-RD-18 from the CIODS rear lamps relay on fuse block 4 (location D7). Cut terminal from end of the wire. Insulate the cut end of the wire to prevent a possible short.
Isolate the end of wire 129-M143-RD-18 and tie the wire back to the harness.
Plug 202-0313 Terminal As into fuse block 4 at location D7. Splice the other end of 202-0313 Terminal As in to circuit 308-M17-YL-16 (Keyswitch) at