PISTON AS 4P3953 - Caterpillar

System Operation Description:The Engine Control Switch (ECS) can operate in four modes: OFF/RESET, START, STOP and REMOTE.The Primary Electronic Control Module (ECM) receives three signals that allow the ECM to determine the mode of operation. The input signals on P1-21 and P1-22 tell the ECM the position of the ECS. The input signals on P1-21 and P1-22 must be at the same potential or a diagnostic code will be generated. The third input signal on P1-68 tells the ECM if the ECS is in the REMOTE position. If the input signal on P1-68 is low, the ECM knows that the ECS is in the REMOTE position. The ECM knows that the engine is controlled remotely by the customer. If the input signal on P1-68 is not low, the ECM knows that the ECS is not in the REMOTE position. The ECM knows that the engine is controlled locally by the ECS on the instrument panel.When the ECS is in the REMOTE position, inputs from the customer control the operation of the engine. The following list contains some of the inputs from the customer connector and the inputs function.
C remote start 2
D remote start 1
E remote stop 1
F remote stop 2
S remote input
-C keyswitchWhen the ECS is in the REMOTE position, the "Remote Start" relay and the "Remote Stop" relay are energized. When the remote start inputs C and D go low, the following relays energize: "Run 1" relay, "Run 2" relay, "Reset 1" relay and "Reset 2" relay. The start/run/stop inputs P1-21 and P1-22 will be pulled low. The engine will begin the start cycle. When the customer's remote stop inputs F and E are low, the following relays energize: "Stop 1" relay and "Stop 2" relay. The start/run/stop inputs P1-21 and P1-22 will be high. The engine will begin the stop function. When the ECS is in the REMOTE position, the "ECS in Remote" relay energizes. The "ECS in Remote" relay sends a signal to the customer connector that allows the customer to determine the position of the ECS.When the ECS is in the START position, the following relays energize: "Run 1" relay, "Run 2" relay, "Reset 1" relay and "Reset 2" relay. The start/run/stop inputs P1-21 and P1-22 will be pulled low. The engine will begin the start cycle.When the ECS is in the STOP position, the following relays energize: "Stop 1" relay and "Stop 2" relay. The start/run/stop inputs P1-21 and P1-22 will be high.When the ECS is in the OFF/RESET position, none of the relays are energized.
Illustration 1 g00991229
Typical example
Test Step 1. Check for Connector Damage.
Turn the circuit breaker for the battery to the OFF position.
Turn the ECS to the OFF/RESET position.
Thoroughly inspect the ECM connectors J1/P1 and J2/P2. Inspect all of the other connectors. Refer to the diagnostic functional test Troubleshooting, "Inspecting Electrical Connectors" for details.
Perform a 45 N (10 lb) pull test on each of the wires in the ECM connector that are associated with the circuit.
Check the ECM connector (allen head screw)