PISTON 5J3025 - Caterpillar

Enabling the Cameras in the Monitor
Once the camera is installed, the camera must be enabled through the monitor. Use the following steps to enable camera.Note: This procedure cannot be done through CAT ET. The procedure must be completed through the monitor.
Illustration 13 g03363567
(14) "Home" key
Press "Home" key (14) to display the main menu
Illustration 14 g03363561
(15) "Left" key
(16) "Down" key
(17) "Up" key
(18) "Right" key
(19) "OK" key
(20) Keypad guidance area
Illustration 15 g03363562
(21) "Service" menu
Using the keypad, scroll down to select the "Service" menu (21).
Illustration 16 g03363544
"Password Entry" menu
Using the keypad, enter the service password (9992) and press the "Enter" key.
Illustration 17 g03363543
(22) "Configurations" menu
Scroll down and select the "Configurations" menu (22).
Illustration 18 g03363558
(23) "Camera Inputs" menu
Scroll down and select the "Camera Inputs" menu (23).
Illustration 19 g03363563
"Camera Inputs" menu
Scroll down to "Camera #2 Installation". Change "Camera #2 Installation" from "Not Installed" to "Optional Camera (NTSC)". Press "OK" to confirm the change. If needed, repeat for "Camera #3 Installation".Note: For each camera installation, change the "Direction", "Mounting Angle", "Angle Adjust", "Contrast", "Brightness", "Color", and "Tint" in "Camera inputs" as needed.Note: If the "Camera Inputs" menu settings are changed, check the "Display Settings" menu (24). for the desired settings.
Press "Home" key (14) to return the main menu, view the camera, or to access the "Display Settings" menu.
Illustration 20 g03363566
(24) "Display Settings" menu
Select "Display Settings" menu (24).
Illustration 21 g03363555
(25) "Default Screen Setting" menu
Scroll down and select "Default Screen Setting" menu (25).
Illustration 22 g03363556
"Default Screen Setting" menu
Select "Default Screen Type #2" and change the screen composition and select screen composition to display. If needed, repeat for "Default Screen Type #3".
Verify the camera angle, brightness, and contrast. If necessary, make the required changes through the "Camera Inputs" menu (23) or physically adjust the rear view camera.Note: If the "Camera Inputs" menu settings are changed, check the "Display Settings" menu (24) for desired settings.
The display style of the operator monitor screen can be changed to an operators preference. Push key "6" of the switch panel. Choose between one camera displayed on the screen, or up to all three camera inputs displayed at once.Note: The recommendation is that only one camera input is displayed. The operator is able to change between each additional camera input as needed.