PISTON 5J4332 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Personal injury or death can result from sudden work tool movement.Sudden movement of the work tool can cause injury to persons near the work tool.To prevent injury or death, make sure that the area around the work tool is clear of personnel and obstructions before operating the work tool.
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Personal injury can result from flame cutting or welding on painted areas.The effect of gasses from burned paint is a hazard to the person doing the cutting or welding.Do not flame cut or weld on painted areas.
Before carrying out arc welding on the machine or on any equipment attached to the machine, disconnect all power and ground leads from the batteries in order to avoid possible damage to electronic components.
Parts Section
Table 1
511-7527 Control Ar-Coupler (- 00)
Qty Part No. Part Name Media
(1) 448-4756 Film Gp -
(1) 493-6643 Cab Wiring Gp M0069198
(1) 502-5978 Chassis Wiring Gp M0071134
(1) 485-3079 Front Lines Gp M0071136
(1) 343-8342 Hydraulic Lines Kit REHS3854 Installation of the 448-4756 Film Gp
Illustration 2 g02454257
Left side view of the cab
(1) 268-4531 Film
(2) 268-8872 Film (For U.S)
(2) 269-0121 Film (For INTL)Tuning Section
Set the machine tool control system.
Reference: Excavator Tool Control System, KENR9986, "Testing and Adjusting Section", "Process for setting Up the Work Tool"Program the machine ECM to recognize the components that have been installedCalibrate the machine electronic control system.
Reference: Excavator Tool Control System, KENR9986, "Testing and Adjusting Section", "Calibration"Calibrate the different components that have been installed. These components may include: Foot Pedal, Thumb wheels, Attachment valve, Flow Limit valve, Variable Relief valves, and Pilot Pressure Limit valves.Set