PLATE 0012259 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01479572
Typical example
Slide locking tab (1) into the unlocked position.
Disconnect harness assembly (2) from position sensor (3).
Remove bolt (4).
Carefully remove position sensor (3) from the cylinder block. Note: Do not use a lever to remove the position sensor from the cylinder block.
Remove O-ring seal (5) from position sensor (3). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-6396 O-Ring Assembly Compound 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01479572
Typical example
Install a new O-ring seal (5) to the groove in position sensor (3). Lubricate the new O-ring seal with Tooling (A).
Align the hole in position sensor (3) with the hole in the cylinder block. Install the position sensor to the cylinder block. Note: Do not use bolt (4) to pull the position sensor into position against the cylinder block.
Install bolt (4). Tighten the bolt to a torque of 22 N m (16 lb ft).
Connect harness assembly (2) to position sensor (3).
Slide locking tab (1) into the locked position.