PLATE 0053325 - Caterpillar

Removal Procedure
Accidental engine starting can cause injury or death to personnel working on the equipment.To avoid accidental engine starting, disconnect the battery cable from the negative (−) battery terminal. Completely tape all metal surfaces of the disconnected battery cable end in order to prevent contact with other metal surfaces which could activate the engine electrical system.Place a Do Not Operate tag at the Start/Stop switch location to inform personnel that the equipment is being worked on.
Turn the battery disconnect switch to the OFF position.
Place identification marks on the harness assembly that is connected to the electric starting motor and the solenoid.
Illustration 1 g02646292
Typical example
Disconnect the harness assembly from the electric starting motor and the solenoid.
Support electric starting motor (3). Remove nuts (2).
Remove electric starting motor (3) from flywheel housing (1).
If necessary, remove studs (5) from flywheel housing (1). Installation Procedure
Illustration 2 g02646292
Typical example
If necessary, install studs (5) into flywheel housing (1). Tighten M10 studs to a torque of 18 N m (159 lb in).
Position electric starting motor (3) onto the studs in flywheel housing (1).
Install nuts (2). Tighten M10 nuts to a torque of 44 N m (33 lb ft).
Connect the harness assembly to the electric starting motor and the solenoid.
Turn the battery disconnect switch to the ON position.