0691566 PLATE Caterpillar parts
30/30, CB-614, D350E, D350E II, D400E, D400E II, D40D, DEUCE
Rating:
Alternative (cross code) number:
CA0691566
069-1566
0691566
CA0691566
069-1566
0691566
Weight: 0.32 pounds 0 kg.
ARTICULATED TRUCK, VIBRATORY COMPACTOR,
Compatible equipment models: 0691566:
Number on catalog scheme:
6
For full view, you need register
Information:
Illustration 1 g02149813
Schematic of the torque limiting indicatorNote: Check that the machine is not in the reduced torque mode.Note: Ensure that the machine is not within the operating range of transmitters.Test Step 1. CHECK HARNESS FOR A SHORT TO FRAME GROUND
Turn the key start switch and the battery disconnect switch to the OFF position.
Disconnect the machine harness connector J2 from the Power Train/Chassis Electronic Control Module (ECM).
Disconnect the machine harness connector from the torque limiting indicator.
At the machine harness connector J2 for the ECM, measure the resistance from J2-11 (wire H468-OR) to all possible sources of frame ground.Expected Result:The resistance for each measurement should be greater than 5 ohms.Results:
YES - The resistance is greater than 5 ohms. Proceed to Test Step 2.
NO - The resistance is less than 5 ohms.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE LAMP PANEL
Reconnect the harness connector to the torque limiting control indicator.
The machine harness connector J2 remains disconnected from the ECM.
Turn the battery disconnect switch and the key start switch to the ON position.Expected Result:The indicator lamp for torque limiting does not illuminate.Results:
YES - The indicator lamp for torque limiting does not illuminate, the warning lamp panel is OK. Proceed to Test Step 3.
NO - The indicator lamp for torque limiting is on continuously, the warning lamp panel has failed.Repair: Remove and replace the warning lamp panel.STOPTest Step 3. CHECK IF THE PROBLEM REMAINS
Turn the key start switch and the battery disconnect switch to the OFF position.
Inspect the contacts of the harness connectors and clean the harness connectors.
Reconnect all the harness connectors.
Turn the battery disconnect switch and the key start switch to the ON position.
Operate the machine.
Check to see if the fault still occurs. Expected Result:The fault is present.Results:
YES - The fault is present. The fault has not been corrected. The ECM may have failed.Repair: The ECM would be unlikely to have failed. Exit this procedure and perform this procedure again. If the cause of the fault is not found, replace the ECM. Refer to Systems operation, Troubleshooting, Testing, and Adjusting, "Electronic Control Module (ECM) - Replace" for the machine that is being serviced.STOP
NO - The fault is no longer present. The fault does not exist at this time.Repair: The initial fault was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation.STOP
Caterpillar parts catalog:
Parts plate Caterpillar catalog:
1090, 1190, 1190T, 120M, 120M 2, 1290T, 12M 2, 12M 3, 12M 3 AWD, 1390, 140M, 140M 2, 140M 3, 140M 3 AWD, 14H, 14M, 160M, 160M 2, 160M 3, 160M 3 AWD, 16H NA, 16M, 2290, 235, 235D, 2390, 2391, 245, 2491...
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12E, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14H, 14H NA, 160G, 160H, 160H ES, 160H NA, 160K, ...
30/30, 428, 5130, 65C, 75C, 75D, 85C, 85D, 918F, 924F, 928F, 928G, 928H, 928HZ, AP-1000, AP-1000B, AP-1055B, AP-650B, AP-800C, AP-800D, AP-900B, BG-225B, BG-225C, BG-2455C, BG-245C, D4H, D4H XL, D4HTS...
30/30, 572R, 572R II, 578, 583R, 583T, 587R, 587T, 611, 615, 615C, 814B, 814F, 814F II, 815B, 815F, 815F II, 816F, 816F II, 966D, 966F, 966F II, 966G, 966G II, 970F, 972G, 972G II, 972H, 972K, 980C, 9...
30/30, 517, 527, D4H, D4H XL, D4HTSK II, D4HTSK III, D5H, D5H XL, D5HTSK II, DEUCE
215, 215B, 225, 229, 235, 235B, 235D, 245, 245B, 24H, 24M, 5110B, 5130, 5130B, 5230, 5230B, 528, 589, 621, 621B, 621E, 621F, 621G, 621R, 623E, 623F, 623G, 627B, 627E, 627F, 627G, 631C, 631E, 631G, 633...
235D, 365B, 365B II, 740, 740B, 769C, 769D, 771C, 771D, 772B, 773B, 773D, 775B, 775D, 776C, 776D, 777D, 824G II, 824H, 834B, 834G, 834H, 836, 836G, 836H, 844, 844H, 844K, 854G, 854K, 950F, 950F II, 95...
24H, 24M, 589, 627E, 627F, 627G, 627H, 627K, 627K LRC, 637E, 637G, 824G, 824G II, 824H, 824K, 825G, 825G II, 825H, 825K, 826C, 826G, 826G II, 826H, 826K, 834B, 834G, 834H, 834K, 836, 836G, 836H, 836K,...
12H, 140H, 14H, 16H, 330C, 330C FM, 330C L, 330C MH, 621G, 623G, 627G, 631E, 631G, 637E, 637G, 725, 730, 735, 735B, 740, 740B, 844K, 938G, 950G, 990K, 993K, D10N, D10R, D10T, D250E II, D300E II, D350E...
518, 528, 528B, 530B, 611, 613C, 613C II, 613G, 615, 615C, 725, 725C, 730, 730C, 735, 735B, 740, 740B, 814B, 815B, 816B, 950B, 950B/950E, 966D, 966F, D25C, D25D, D300E, D300E II, D30C, D350C, D350E, D...
12H, 140H, 14H, 16H, 621G, 623G, 627G, 631G, 637G, 735, 735B, 740, 740B, 844K, 990K, 993K, D350E II, D400E II
631E, 637E, 69D, 735, 735B, 740, 740B, 768C, 769C, 769D, 770, 770G, 770G OEM, 771C, 771D, 772, 772G, 772G OEM, AD40, AD45, AD45B, AD55, AE40, AE40 II, D400E II
30/30, 572R, 572R II, 578, 583R, 583T, 587R, 587T, 611, 615C, 814B, 814F, 815B, 815F, 816F, 966D, 966F, 966F II, 970F, 980C, 980F, 980F II, 980G, 980G II, 980H, 980K, D250E, D250E II, D25D, D300E, D30...
30/30, 572R, 572R II, 578, 583R, 583T, 587R, 587T, 611, 615, 615C, 814B, 814F, 814F II, 815B, 815F, 815F II, 816F, 816F II, 966D, 966F, 966F II, 966G, 966G II, 970F, 972G, 972G II, 972H, 972K, 980C, 9...
30/30, 572R, 572R II, 578, 583R, 583T, 587R, 587T, 611, 615, 615C, 814B, 814F, 814F II, 815B, 815F, 815F II, 816F, 816F II, 966D, 966F, 966F II, 966G, 966G II, 970F, 972G, 972G II, 972H, 972K, 972M, 9...
9W8529
PLATE-CLUTCH
30/30, 611, 615, 615C, D250B, D250E, D250E II, D25C, D25D, D300E, D300E II, DEUCE
30/30, 611, 615, 615C, D250B, D250E, D250E II, D25C, D25D, D300E, D300E II, DEUCE
30/30, 611, 615, 615C, D250E, D250E II, D25D, D300E, D300E II, DEUCE
30/30, 572R, 572R II, 578, 583R, 583T, 587R, 587T, 611, 615, 615C, 637E, 69D, 735, 735B, 740, 740B, 768C, 769C, 769D, 770, 770G, 770G OEM, 771C, 771D, 772, 772G, 772G OEM, 776C, 776D, 777B, 777D, 777F...
1659876
PLATE AS
30/30, DEUCE
30/30, DEUCE
1659875
PLATE AS
30/30, DEUCE
30/30, DEUCE
9G7974
PLATE-CENTER
30/30, 611, 613C, 613C II, 613G, 615, 615C, D250B, D250E, D250E II, D300B, D300E, D300E II, DEUCE
30/30, 611, 613C, 613C II, 613G, 615, 615C, D250B, D250E, D250E II, D300B, D300E, D300E II, DEUCE
8P9785
PLATE
30/30, 611, 613C, 613C II, 613G, 615, 615C, D250B, D250E, D250E II, D25D, D300B, D300E, D300E II, DEUCE
30/30, 611, 613C, 613C II, 613G, 615, 615C, D250B, D250E, D250E II, D25D, D300B, D300E, D300E II, DEUCE
1379849
PLATE-IDENTIFICATION
30/30, D250E, D250E II, D300E, D300E II, DEUCE
30/30, D250E, D250E II, D300E, D300E II, DEUCE
1304629
PLATE-CLUTCH BACKING
30/30, 611, 615C, D250D, D250E, D250E II, D25D, D300E, D300E II, DEUCE, R1600, R1600G, R1600H
30/30, 611, 615C, D250D, D250E, D250E II, D25D, D300E, D300E II, DEUCE, R1600, R1600G, R1600H