0874969 PLATE Caterpillar parts
307, 307B, 311, 311B, 312, 312B, 312B L, 315, 315B L, 317, 318B, 320B, 322B, 322B L, 322B LN, 325, 325 L, 325 LN, 325B, 325B L, 330, 330 FM L, 330B L, 345B L, 350, 375, 375 L, 5080, 5130, 5130B, 5230,...
Rating:
Alternative (cross code) number:
CA0874969
087-4969
0874969
CA0874969
087-4969
0874969
Weight: 1 pounds 0 kg.
EXCAVATOR, MINING EXCAVATOR,
Compatible equipment models: 0874969:
Number on catalog scheme:
18
For full view, you need register
Information:
Illustration 1 g02351777
Schematic for the Right Hand Joystick Control sensorNote: The sensor is not directly connected to the frame ground. The sensor return connects to the ECM, and the ECM connects the sensor return to frame ground internally.This diagnostic code is for the Right Hand Joystick Control sensor for reverse and forward motion. An FMI 03 indicates the machine ECM has determined the sensor output signal voltage is above normal. Possible causes for this diagnostic code are:
A failed sensor.
The sensor output signal is shorted to ground.
The machine ECM may have failed, but is unlikely.Note: Poor connections are often the cause of a problem in electrical circuits. Before performing this procedure, inspect all the machine harnesses and connectors involved in the circuit. Make sure to verify that all of the connections in the circuit are clean, secure, and in good condition. Correct any problems found with any of the connections. Verify the diagnostic code CID 1127 FMI 04 is still active, before continuing with this procedure.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes now, but clear those codes when the original diagnostic code has been corrected. Test Step 1. CHECK THE SENSOR
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness connector from the Right Hand Joystick Control sensor.
Turn the disconnect switch and the key start switch to the ON position.
Observe the status of the CID 1127 FMI 04 diagnostic code. Expected Result:The CID 1127 FMI 04 code stays active. Results:
YES - The CID 1127 FMI 04 code stays active. The sensor is not the problem. Go to Test Step 2.
NO - The CID 1127 FMI 04 code is no longer active and has been replaced by an active CID 1127 FMI 03 code. The sensor has failed. Repair: Replace the sensor. The new sensor will need to be calibrated. Go to Test Step 3.Test Step 2. CHECK THE SENSOR CIRCUIT FOR A SHORT.
Turn the key start switch and the disconnect switch to the OFF position.
The sensor harness connector stays disconnected.
Disconnect both the J1 and J2 machine harness connectors from the machine ECM.
At the ECM harness connectors, measure the resistance from the contact J1-24 (wire M963-BU) to all of the other contacts that are used in both the J1 and J2 ECM harness connectors. Expected Result:Each resistance measured is more than 5000 ohms. Results:
YES - Each resistance measured is more than 5000 ohms. The machine harness is correct. Go to Test Step 3.
NO - A resistance measured is not more than 5000 ohms. There is a short in the machine harness. The short is between J1-24 (wire M963-BU) and the circuit with the low resistance.Repair: Repair or replace the harness. Go to Test Step 3.Test Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Reconnect all harness connectors. Make sure that the connectors are fully seated. Observe that the clips on each connector are securely fastened.
Turn the disconnect switch and the key start switch to the ON position.
Clear
Cat SIS web machinery list:
Parts plate Caterpillar catalog:
325, 325 L, 325 LN, 325C, 328D LCR, 330, 330 FM L, 330 L, 330B, 330B L, 330C, 330C FM, 330C L, 330C MH, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E HVG, 3...
320 L, 320N, 325, 325 L, 325 LN, E120B, E200B, E240C, OEMS
320 L, 320N, 325, 325 L, 325 LN, E120B, E180, E200B, E240, E240C, EL240B, OEMS
330, 330 FM L, 330 L, 350, E300B, OEMS
330, 330 FM L, 330 L
330, 330 FM L, 330 L, 330B, 330B L, 345B, 345B L, W330B
330, 330 FM L, 330 L, 330B, 330B L, 345B, 345B L, W330B
330, 330 FM L, 330 L, 330B, 330B L, 345B, 345B L, W330B
330D L, 330D LN, 330D MH, 345B, 345B II, 345B II MH, 345B L, W345B II
345B II, 345B II MH, 345B L, W345B II
345B II, 345B II MH, 345B L, W345B II
345B II, 345B II MH, 345B L, W345B II
0940872
PLATE
307, 307B, 311, 311B, 312, 312B, 312B L, 315, 315B L, 317, 318B, 320B, 322B, 322B L, 322B LN, 325, 325 L, 325 LN, 325B, 325B L, 330, 330 FM L, 330B L, 345B L, 350, 375, 375 L, 5080, 5130, 5230, E110, ...
307, 307B, 311, 311B, 312, 312B, 312B L, 315, 315B L, 317, 318B, 320B, 322B, 322B L, 322B LN, 325, 325 L, 325 LN, 325B, 325B L, 330, 330 FM L, 330B L, 345B L, 350, 375, 375 L, 5080, 5130, 5230, E110, ...
4I6366
PLATE
307, 307B, 311, 311B, 312, 312B, 312B L, 313B, 315, 315B L, 317, 318B, 320B, 322B, 322B L, 322B LN, 325, 325 L, 325 LN, 325B, 325B L, 330, 330 FM L, 330B L, 345B L, 350, 375, 375 L, 5080, 5130, 5130B,...
307, 307B, 311, 311B, 312, 312B, 312B L, 313B, 315, 315B L, 317, 318B, 320B, 322B, 322B L, 322B LN, 325, 325 L, 325 LN, 325B, 325B L, 330, 330 FM L, 330B L, 345B L, 350, 375, 375 L, 5080, 5130, 5130B,...
6C6084
PLATE
307, 320 L, 320B, 320C, 322 LN, 322B LN, 322C, 324D, 324D LN, 325 L, 325 LN, 325B L, 325C, 325D, 325D L, 329D L, 329D LN, 330 L, 330B L, 330C, 330C L, 330D L, 345B II, 345B L, 345C, 345C L, 349E L HVG...
307, 320 L, 320B, 320C, 322 LN, 322B LN, 322C, 324D, 324D LN, 325 L, 325 LN, 325B L, 325C, 325D, 325D L, 329D L, 329D LN, 330 L, 330B L, 330C, 330C L, 330D L, 345B II, 345B L, 345C, 345C L, 349E L HVG...
7Y4090
PLATE
307, 330B L, 330C, 330C L, 345B II, 345B L, 521B, 522B, 621H, 621K, 623H, 623K, 623K LRC, 627H, 627K, 627K LRC, 824G II, 824H, 980M, 982M, 992G, 992K, 993K, M325D L MH, M325D MH
307, 330B L, 330C, 330C L, 345B II, 345B L, 521B, 522B, 621H, 621K, 623H, 623K, 623K LRC, 627H, 627K, 627K LRC, 824G II, 824H, 980M, 982M, 992G, 992K, 993K, M325D L MH, M325D MH
1093534
PLATE
307
307
1137183
PLATE AS
307
307
7Y3430
PLATE
307, 307B, 311, 312, 312B, 312B L, 312C, 315, 317, 320B FM LL, 320N, 322, 325, 325B, 330, 330 L, 330B, 345B II, 345C, 345C L, 350, 950G, 950G II, 950K, 962G, 962G II, 962K, IT62G II, OEMS
307, 307B, 311, 312, 312B, 312B L, 312C, 315, 317, 320B FM LL, 320N, 322, 325, 325B, 330, 330 L, 330B, 345B II, 345C, 345C L, 350, 950G, 950G II, 950K, 962G, 962G II, 962K, IT62G II, OEMS
1026521
PLATE
311, 311B, 312, 315, 317, OEMS
311, 311B, 312, 315, 317, OEMS
1026533
PLATE
311, 311B, 312, 315, 317, OEMS
311, 311B, 312, 315, 317, OEMS
1164468
PLATE
307, 312
307, 312
0858824
PLATE
307, 307B, 307C, 308C, 312C L, E70B
307, 307B, 307C, 308C, 312C L, E70B
4I1764
PLATE
307, 307C, 308C, 312, 312B L, 312C, 312C L, 314C, 315, 315B L, 315C, 317, 318B, 318C, 320B, 320C, 320C FM, 321C, 322B L, 322B LN, 322C, 325 LN, 325B L, 325C, 330, 330 FM L, 330B L, 330C, 330C L, 345B ...
307, 307C, 308C, 312, 312B L, 312C, 312C L, 314C, 315, 315B L, 315C, 317, 318B, 318C, 320B, 320C, 320C FM, 321C, 322B L, 322B LN, 322C, 325 LN, 325B L, 325C, 330, 330 FM L, 330B L, 330C, 330C L, 345B ...