AVSPARE.COM
parts catalog

PLATE A 0876420 - Caterpillar



0876420 PLATE A Caterpillar parts PLATE
Rating:
11
Alternative (cross code) number:
CA0876420
087-6420
0876420
Caterpillar 0876420 PLATE A

Buy PLATE A 0876420 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 187-2718 Filter Wrench 1
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes.
Open the left access panel and turn the battery disconnect switch to the OFF position.
Open the right side access panel.
Illustration 1 g06256647
Disconnect wire assembly (1) from filter base (2).
Disconnect hose assemblies (3), and (4), and position out of the way.
Use Tooling (A) and remove hydraulic oil filter (5) from filter base (2).
Illustration 2 g06256634
Remove four bolts (6) and the washers. Remove filter base (2).Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 187-2718 Filter Wrench 1
Install hydraulic oil filter (5) in the reverse order of removal.
Tighten bolts (6) to a torque of 30 7 N m (266 62 lb in).


Parts plate Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.