AVSPARE.COM
parts catalog

PLATE ENG HOOD 0878129 - Caterpillar



0878129 PLATE ENG HOOD Caterpillar parts PLATE
Rating:
26
Alternative (cross code) number:
CA0878129
087-8129
0878129
Caterpillar 0878129 PLATE ENG HOOD

Buy PLATE ENG HOOD 0878129 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 17 g03713622
Remove the screws and the washers. Push harness assembly (25) through the opening on the machine.
Illustration 18 g03714003
Open both access panels (26) .
Illustration 19 g03713623
Disconnect three connectors (27) from the clips on the rear inner frame.
Illustration 20 g03713635
Remove the two screws (30) and the wire assemblies.
Disconnect connector (29) .
Remove cable straps (28). Pull harness assembly (25) out form under hose assemblies at the rear of the tractor.
Illustration 21 g03713698
Remove the cable straps. Loosen the screws and disconnect connectors (31) .
Illustration 22 g03713701
Remove the cable straps. Loosen the screws and disconnect connectors (32) .
Disconnect connector (33) .
Illustration 23 g03713702
Open the right access door. Remove the cable straps and disconnect antenna harness assembly (34). Place antenna harness assembly (34) under the access cover.
Illustration 24 g03713730
Use two people to remove doors (26). Remove the bolts and doors (26) .
Illustration 25 g03713733
Remove three bolts (35) and the three washers from both sides of the machine.
Illustration 26 g03713735
Remove three bolts (36) and the three washers from both sides of the machine.
Illustration 27 g03714038
Attach a suitable lifting device to fumes stack (37). the weight of fumes stack (37) is approximately 20 kg (44 lb). Remove the four bolts, the four washers, and fumes stack (37) .
Illustration 28 g03713739
Attach a suitable lifting device to access cover (38). The weight of access cover (38) is approximately 1810 kg (400 lb).Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Brackets     3    
Install access cover (38) in the reverse order of removal.
Connect harness assemblies (32) and tighten the screws. Tighten the screws to a torque of 2.25 0.25 N m (20 2.21 lb in).
Connect harness assembly (31) and tighten the bolt. Tighten the screw to a torque of 2.25 0.25 N m (20 2.21 lb in).
Tighten bolt (20) to a torque of 15 3 N m (133 27 lb in).End By: Install the batteries. Refer to Disassembly and Assembly, "Battery - Remove and Install".


Parts plate Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.