PLATE-SPACER 1003411 - Caterpillar

There are two types of configuration parameters:system configuration parameters and customer configuration parameters.System Configuration Parameters
System configuration parameters affect the emissions of the engine or the power of the engine. The parameters are stored in the Engine Control Module (ECM). Use the Caterpillar Electronic Technician (ET) to view the values of the parameters and change the values of the parameters. Refer to Troubleshooting Guide, "System Configuration Parameters" for further information.Customer Configuration Parameters
Customer specified parameters allow the vehicle owner to influence the operating technique of a driver. Some parameters may affect engine operation in a way that would not be expected by an inadequately trained driver. These parameters may lead to power or performance complaints even though the engine's performance is within the engine's specification.Customer parameters may be changed repeatedly as a customer's operation changes or as new drivers are assigned to a truck. Customer passwords are required to change these parameters. The customer password must be programmed into the Engine Control Module (ECM). Refer to Troubleshooting Guide, "Customer Specified Parameters" and refer to Troubleshooting Guide, "Customer Specified Parameters Table" for further information.Worksheet for Customer Specified Parameters
Use the following worksheet in order to record the parameters for your engine.
Table 1
Selected Engine Rating    
Rating Number    
   
Rating Type    
   
Multitorque Ratio    
   
Advertised Power    
   
Governed Speed    
   
Rated Peak Torque    
   
Top Engine Speed Range    
   
Test Spec    
   
Test Spec with BrakeSaver    
   
Table 2
ECM Identification Parameters    
Vehicle ID    
   
Engine Serial Number    
   
ECM Serial Number    
   
Personality Module Part Number    
   
Personality Module Release Date    
   
Table 3
Security Access Parameters    
Total Tattletale    
   
Last Tool to change Customer Parameters    
   
Last Tool to change System Parameters    
   
ECM Wireless Communication Enable