PLATE 1100976 - Caterpillar

Activating Memory
Illustration 1 g00103165
Press alarm cancel switch (5) and switch (4) for user mode simultaneously for more than two seconds. When display (6) flashes, the customer mode can be set by using the following switches.Switch (1) for Boom Priority Mode - The flashing value in the LCD will increase when this switch is pressed.Switch (2) for Swing Priority Mode - The flashing value in the LCD will decrease when this switch is pressed.Switch (3) for Fine Control Mode - The selected flashing position on the LCD will move by one position to the right when this switch is pressed.Switch (4) for User Mode - The selected flashing position on the LCD will move by one position to the left when this switch is pressed.Values can be entered only in the position that is flashing on the LCD. Use switch (3) and switch (4) to move the flashing position to the right or to the left.To return to the normal operating mode, push alarm cancel switch (5) and switch (4) for mode simultaneously for more than two seconds. Display (6) will show the time of day and the position of the engine speed dial.
Illustration 2 g00103167
Illustration 2 indicates that time of day (A) is 11:30 and the position of the engine speed dial is "10".Selecting a Sub-mode
Illustration 3 g00103168
Position (A) and position (B) indicate the sub-mode.
"U1" indicates the tamping mode. No setting is required for the tamping mode.
"U2" indicates mode U2. No setting is required for mode U2.
"U3" indicates the customer mode. The settings for the customer mode can now be set.If the appropriate sub-mode is not displayed on the LCD, use switch (3) or switch (4) to move the flashing character to position (B). Use switch (1) or switch (2) to change the designation of the sub-mode.Setting the Customer Mode
To set the user mode, the character in position (B) must be a "3".Position (C) is used to select one of the four parameters. Positions (D), (E), and (F) are used to set the function of the parameter.Refer to the following table in order to determine the values of the positions that will achieve the desired function of the hydraulic excavator while you are operating the machine in the user mode.
Table 1
Positions (A) and (B)    Position (C)    Positions (D), (E), and (F)    
Setting    Function    Setting    Function    
"U3" Customer Mode     "1"     Select work mode.     "--1"     Select boom priority mode.    
"--2" Select swing priority mode.    
"--3" Select fine control mode.    
"2" Select power mode.     "--1"     Power mode is off.    
"--2" Power mode is on.    
"3" Select the stage of AEC.     "--1"     Select the first stage of AEC.    
"--2" Select the second stage of AEC.    
"5" Set the time delay for the AEC.     "---"     The increment is 0.1 second and the range is 0.1 second to 20 seconds. The initial factory setting for the delay time is 3 seconds. The LCD