PLATE 1161367 - Caterpillar

Wiring to a 70 Position Product Link Connector
Illustration 52 g06284866Note: If the asset has a 70 position Product Link connector that branches directly off the machine harness and connects to a legacy Product Link ECM, the wires in the 70 position connector can be used to connect the 467-9246 Wiring Harness.
Remove the end bell from the 70 position Product Link connector.
Remove the following eight wires from the 70 position Product Link connector:
Battery positive.
Battery negative.
Key switch.
R-Term.
CDL positive.
CDL negative.
J1939 positive.
J1939 negative.
Insert the wires from Step 2 into a 155-2252 Connector Plug As as shown in Table 32.
Table 32
Position Wire
1 Battery positive
2 Battery negative
3 Key switch
4 R-Term
5 CDL positive
6 CDL negative
7 J1939 positive
8 J1939 negative
Insert 8T-8737 Seal Plugs into the unused locations in the 155-2252 Connector Plug As.
Crimp an 8T-8729 Connector Pin onto each wire of the 467-9246 Wiring Harness.
Install a 102-8801 Receptacle Kit onto the 467-9246 Wiring Harness as shown in Table 33.
Table 33
Position Wire
1 Battery positive 125-RD(Red).
2 Battery negative200-BK(Black).
3 Key switch 308-YL(Yellow).
4 R-Term 403-GN(Green).
5 CDL positive 893-GN(Green).
6 CDL negative 892-BR(Brown).
7 J1939 positive F711-YL(Yellow).
8 J1939 negative F712-GN(Green).
Insert 8T-8737 Seal Plugs into the unused locations in the 102-8801 Receptacle Kit.
Insert the 102-8801 Receptacle Kit onto the 155-2252 Connector Plug As on the asset.
Connect "C1" of the 467-9246 Wiring Harness to the 12-pin connector on the radio.Connecting a Computer to the Product Link System
Required Software
This system requires Cat® Electronic Technician (Cat ET) version 2014A or later.Note: Caterpillar recommends that Cat ET to be updated to the latest version to access all the available functionality in this Product LinkTM system.Supported Hardware Connections
The Product Link device is configured with Cat ET using the following communications interfaces:
The 171-4400 Communication Adapter Gp or 466-6258 Communication Adapter Gp is connected between the machine service connector and the PC serial port or parallel port.
The Cat ET Communications Interface Device is configured for Cat Communications Adapter II (RP1210) or Cat Communication Adapter 3 (RP1210).Note: The configuration parameters for the "Communications Interface Device" are found