PLATE AS 1180045 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.
Illustration 15 g00820597
Attach a suitable lifting device onto the front of ejector cylinder (5). Attach Tooling (A) onto rear of ejector cylinder (5). The weight of ejector cylinder (5) is approximately 249 kg (550 lb). Position ejector cylinder (5) .
Illustration 16 g00820598
Install pin (8) and retainer (7) .
Illustration 17 g00820596
Lower ejector cylinder (5) until the rear of the ejector cylinder (5) rests on ejector assembly (2).
Install a suitable lifting device onto ejector cylinder (5) in order to install suitable cribbing.
Use Tooling (A) in order to move the ejector assembly toward the rear of the bowl.Note: Keep tension on Tooling (A) at all times in order to prevent unexpected movement of the ejector assembly.
Illustration 18 g00820594
Install Tooling (C). Remove the suitable cribbing from ejector assembly (2) .
Illustration 19 g00820592
Illustration 20 g00820590
Lower ejector cylinder (5) onto differential axle housing (9) .
Use Tooling (A) in order to move the ejector assembly toward the rear of the bowl.Note: Keep tension on Tooling (A) at all times in order to prevent unexpected movement of the ejector assembly.
Install Tooling (B) onto ejector cylinder (5) .
Illustration 21 g00820591
Install pin (8) and retaining cap (7) .
Illustration 22 g00820589
Install hose assembly (6) onto ejector cylinder (5) .
Illustration 23 g00820588
Install tube assembly (4) onto ejector cylinder (5) .
Illustration 24 g00821097
Remove the suitable cribbing from the scraper bowl.End By: Install the overflow guard. Refer to Disassembly and Assembly, "Overflow Guard - Remove and Install".