PLATE 1246374 - Caterpillar

Machine Preparation
Move machine to a level surface.
Apply parking brake. Turn engine key switch to the OFF position.
Turn the battery disconnect switch to the "OFF" position.
Illustration 1 g00104545
Perform Lockout Tag Out procedure by attaching a warning tag to the machine controls.Procedure
Refer to Disassembly and Assembly Manual , UENR3334 , "Cab - Remove and Install" and remove the cab.
Illustration 2 g06253287
(A) Pump 1
(B) Pump 2
Hang up pump 2 as shown in Illustration 2, in order to protect the O-ring.
Illustration 3 g06253293
(C) 390-5984 Plate
(D) Bolt
Disassemble the plate (C) by removing four bolts (D).
Illustration 4 g06253296
(B) Pump 2
(E) Bolt
Remove two mounting bolts (E) from pump 2 (B).
Illustration 5 g06253297
(1) 8T-0348 Bolt
(2) 9X-8268 Washer
(3) 524-7610 Bracket
(4) 6V-4249 Bolt
(5) 489-1638 Spacer
(6) 8T-4133 Nut
(7) 7X-7729 Washer
(8) 524-7612 Bracket
(9) 524-7616 Bracket
(10) 524-7609 Bracket
Use the mounting slots of pump 2 to install bracket (3) and bracket (8) using two bolts (1) and two washers (2). Torque the bolts to 270 40 N m (199 29 lb ft).Place bracket (9) and bracket (10) as shown in Illustration 5 and install using four bolts (4), four spacers (5), four nuts (4), and two washers (7). Torque the bolts to 60 12 N m (44 9 lb ft).
Illustration 6 g06253305
(10) 524-7609 Bracket
(11) 524-7617 Spacer
(12) 8T-0643 Bolt
Secure bracket (10) using three spacers (11) and three bolts (12). Torque the bolts to 60 12 N m (44 9 lb ft).Note: Step 7 is applicable only for M5T machines.
Illustration 7 g06253307
(13) 132-5789 Clip
(14) 4P-7581 Clip
(15) 7K-1181 Cable Strap
(F) Wire
Secure wire (F) using clip (13), clip (14), and two cable straps (15) as shown in Illustration 7.
Refer to Disassembly and Assembly Manual , UENR3334 , "Cab - Remove and Install" to re-install the cab.