PLATE 1253222 - Caterpillar

Apply Fluid Film® to a towel and apply inside the fuel filler neck at the top of the fuel tank.
Illustration 14 g02129853
Tread plate cut outs
Spray Fluid Film® in all tread plate cutouts.
Illustration 15 g02129876
Toolbox
Remove bucket pins, heater cord, shims, liner, and other similar items from the toolbox. Apply Fluid Film® inside the toolbox. Return the items to the toolbox after the toolbox is dry.
All items must be removed to allow full coverage of the toolbox floor.
After all items have been returned to the toolbox, ensure that the toolbox is locked. All locks must be engaged when a prime product is being shipped.
Illustration 16 g02129133
Stick cylinder
Note: Begin with coating the stick cylinder rod before raising any implements.
Illustration 17 g02129037
Bucket cylinder
Illustration 18 g02129075
Boom cylinders
Apply Fluid Film® to the boom, stick, and bucket cylinder rods.
A ladder must be used to reach the appropriate heights safely.
The stick and boom cylinders are too high off the ground when the product is parked in a servicing position.
Illustration 19 g02129573
Battery room
Apply Fluid Film® to the battery room.
Apply Fluid Film® to the battery room floor, inner door and hinges, and the center post.
The afore mentioned areas of the battery room are more likely to affect the customer negatively.
Illustration 20 g02129593
Radiator room
Note: When applying Fluid Film®, be careful not to allow any into the cooling package. If Fluid Film® gets into the cooling fins, dust will accumulate and prevent cooling.
Apply Fluid Film® to the radiator room.Note: Avoid getting Fluid Film® on overflow and drain hoses. Fluid Film® is not compatible with natural rubber.
Apply Fluid Film® to the radiator room floor, inner door and hinges, center post, and the filter base.
Illustration 21 g02129613
Outer left side track
Apply Fluid Film® to the outer left side tracks.
Apply a thin film only to the outer left side of the tracks.
Illustration 22 g02129714
Pump room
Apply Fluid Film® to the pump room.
Apply Fluid Film® to the pump room floor, inner door and hinges, and the center post.
Illustration 23 g02129733
Outer right side track
Apply Fluid Film® to the outer right side tracks.
Apply a thin film only to the outer right side of the tracks.
Illustration 24 g02129833
Inner left and right track
Apply Fluid Film® to the inner left and right side tracks. Applying the film coating will most likely have to be performed while on the creeper.
Apply a thin coat of Fluid Film® only to the inner left and right side tracks.Note: Repeat this application every 90 days. If the machine is stored in sunlight, repeat this application every 45 days.Removal of Fluid Film® From the Machine
When the machine is ready to be removed from storage, the machine needs to have the Fluid Film® removed.Fluid Film® is a vegetable oil base, corrosion protectant. Cleaning is simple, use a power washer, or dealer wash bay to wash the machine. The water temperature should be approximately 49° C (120° F). Use traditional wash bay soaps to remove the Fluid Film®.