PLATE-WEAR 1255542 - Caterpillar

Recover the air conditioner refrigerant from the air conditioner system. Refer to Service Manual, SENR5664, "Air Conditioning and Heating Systems with R-134a Refrigerant" for the procedure. Refer to Special Publication, NEDG5065, "Air Conditioning Tools" for the tools.
Illustration 1 g01380480
Disconnect hose assemblies (1).
Illustration 2 g01380482
Remove plate (2).
Illustration 3 g01380617
Disconnect harness assembly (3).
Illustration 4 g01380618
Attach Tooling (A) and a suitable lifting device to condenser assembly (4). The weight of condenser assembly (4) is approximately 30 kg (55 lb).
Remove bolts (5). Repeat for the other side. Remove condenser assembly (4).
Illustration 5 g01380633
Remove bolts (7) and refrigerant condenser (6). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 2 Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 6 g01380633
Install refrigerant condenser (6) and bolts (7).
Illustration 7 g01380618
Attach Tooling (A) and a suitable lifting device to condenser assembly (4). The weight of condenser assembly (4) is approximately 30 kg (55 lb).
Position condenser assembly (4). Install bolts (5). Repeat for the other side.
Illustration 8 g01380617
Connect harness assembly (3).
Illustration 9 g01380482
Install plate (2).
Illustration 10 g01380480
Connect hose assemblies (1).
Charge the air conditioner system. Refer to Service Manual, SENR5664, "Air Conditioning and Heating Systems with R-134a Refrigerant" for the procedure. Refer to Special Publication, NEDG5065, "Air Conditioning Tools" for the tools. End By:
Install the hood. Refer to Disassembly and Assembly, "Hood - Install".