PLATE AS 1271056 - Caterpillar

Assembly Procedure
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 1 g01195789
Install lip seal (28) .
Illustration 2 g01195788
Install bearing (27), spacer (26), and retaining ring (25) to shaft assembly (23) .
Illustration 3 g01195787
Install shaft assembly (24) .
Install O-ring seal (23) .
Illustration 4 g01195784
Install O-ring seals (22) to plate (20) .
Illustration 5 g01195782
Install coupler (21) and plate (20) .
Illustration 6 g01195780
Install seals (18) and (19) to plate (17).
Install plate (17) .
Illustration 7 g01195778
Install driven gear (15) and drive gear (16) .
Install plate (14) .
Illustration 8 g01195777
Install O-ring seal (13) to body (12) .
Illustration 9 g01195776
Install body (12). Install O-ring seal (11) to body (12) .
Illustration 10 g01195773
Install seals (9) and (10) .
Illustration 11 g01195772
Position cover (7) and install bolts (8) .
Illustration 12 g01195771
Install O-ring seals (5) and (6) to valve (3) .
Install cap (4) to valve (3) .
Illustration 13 g01195769
Install valve (3) to motor (1) .
Install fittings (2) to motor (1) .End By: Install the gear motor (hydraulic fan). Refer to Disassembly and Assembly, "Gear Motor (Hydraulic Fan) - Install".