PLATE 1288424 - Caterpillar

Install mounting bracket (25), two washers (36), two bolts (40). Install tube (26), U-bolt (32), two washers (28), four nuts (33), and clamp (30). Position tube (26) toward the water tank. Install connector assembly (27), hose (41), two clamps (39), clip (31), washer (36), and bolt (37). Position water drain hose (AD) and install two straps (29). Torque the first U-bolt fasteners to 15 3 N m (11 2 lb ft). Torque the second U-bolt fasteners to 28 7 N m (21 5 lb ft). Connect sensor harness assembly (AB) to main harness assembly (AC).
Illustration 18 g06255328
Front Turbo
(AE) 6V-8843 Hose
(42) 9X-2488 Hose Clamp
Connect turbo water vent hose (AE) and install clamp (42) on front turbos.
Illustration 19 g06255399
Rear Turbo
(AF) 6V-8843 Hose
(42) 9X-2488 Hose Clamp
Connect turbo water vent hose (AF) and install clamp (42) on rear turbos.
Illustration 20 g06255404
Muffler Drain
Right-Hand Side
(AG) 6V-8843 Hose
(42) 9X-2488 Hose Clamp
Connect muffler drain hose (AG) and install clamp (42).
Illustration 21 g06255414
Muffler Drain
Left-Hand Side
(AH) 6V-8843 Hose
(42) 9X-2488 Hose Clamp
Connect turbo water vent hose (AH) and install clamp (42).
Illustration 22 g06255417
Right-Hand Side
(AJ) 9X-2133 Hose
(42) 9X-2488 Hose Clamp
(43) 5K-9660 Clip
(44) 8T-4121 Hard Washer
(45) 8T-4137 Bolt
Connect cooling water hoses (AJ) from hood enclosure to cooling pack. Install clamp (42) , clip (43), washer (44), and bolt (45).
Illustration 23 g06255421
Left-Hand Side
(AL) 9X-2133 Hose
(42) 9X-2488 Hose Clamp
(43) 5K-9660 Clip
(44) 8T-4121 Hard Washer
(45) 8T-4137 Bolt
Connect cooling water hoses (AL) from hood enclosure to cooling pack. Install clamp (42) , clip (43), washer (44), and bolt (45).
Illustration 24 g06255445
Right-Hand Side Access
(AM) 479-8224 Hose As
(AN) 479-8225 Hose As
Connect hose assembly (AM) and hose assembly (AN).
Illustration 25 g06255447
CEM Harness Connection
(AP) 474-5800 Harness As
(AR) 300-9462 Plug As 31 PIN
(AS) 311-2812 Connector Plug 23 PIN
Connect plug assembly (AR) and plug assembly (AS) of harness assembly (AP).Commissioning
After the machine has been fully assembled, Refer to "Commissioning Procedure for the 994K Wheel Loader"Special Instruction, REHS8985 to commission the machine.