PLATE 1300528 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     185-3630     Strap Wrench As     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01333853
Typical example
Use Tooling (A) to remove engine oil filter (6) from engine oil filter base (5). Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change".
Mark the orientation of engine oil filter base (5) for installation. Remove bolt (2) .Note: The engine oil filter base can be oriented in different positions.
Remove bolt (4) and remove engine oil filter base (5) from the cylinder block. Plug the oil galleries in the cylinder block with suitable plugs.
Remove O-ring seal (1) from engine oil filter base (5) .
Remove O-ring seal (3) from bolt (4) .Installation Procedure
Illustration 2 g01333853
Typical example
Ensure that the engine oil filter base is clean and free from damage. Clean the mating surfaces of the cylinder block.
Install a new O-ring seal (1) to engine oil filter base (5). Install a new O-ring seal (3) to bolt (4) .
Position engine oil filter base (5) against the cylinder block. Install bolt (4) finger tight.
Ensure the correct orientation of engine oil filter base (5). Install bolt (2) finger tight.Note: The engine oil filter base can be oriented in different positions.
Tighten bolt (4) to a torque of 50 N m (37 lb ft). Tighten bolt (2) to a torque of 11 N m (97 lb in).
Install a new engine oil filter (6). Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the correct procedure.