PLATE AS 1334203 - Caterpillar

Illustration 1 g02725680
Table 1
Specifications for 244-2616 Bevel and Transfer Gear 162-6874 Bevel and Transfer Gear , and 166-3485 Bevel and Transfer Gear    
Item     Qty     Part     Specification Description    
2     1     9P-1922 Shim Pack     As required, use the shim pack with the thickness of 2.01 mm (0.079 inch) in order to obtain the end play of
0.10 0.05 mm (0.004 0.002 inch).    
3     1     0S-1569 Bolt     Torque to
270 40 N m (199 30 lb ft).    
4     12     0L-1169 Bolt     Torque to
270 40 N m (199 30 lb ft).    
5     24     7B-3235 Bolt     Torque to
135 20 N m (100 15 lb ft).    
6     4     0S-1591 Bolt     Torque to
55 10 N m (41 7 lb ft).    
7     1     216-0273 Lip Type Seal     Lubricate the sealing lip lightly with the lubricant that is being sealed.    
8     1     9P-1921 Shim Pack     As required, use the shim pack with the thickness of
2.01 mm (0.079 inch) in order to obtain the end play of
0.10 0.05 mm (0.004 0.002 inch).    
Illustration 2 g02725681
Table 2
Specifications for 244-2616 Bevel and Transfer Gear , 162-6874 Bevel and Transfer Gear , and 166-3485 Bevel and Transfer Gear    
Item     Qty     Part     Specification Description    
9     1     1L-6957 Bearing Locknut     Before assembly, apply Loctite C5A to the threads.    
Torque to
612 68 N m (451 50 lb ft).
10     2     9P-1478 Shim Pack     As required, use shim pack of thickness of
2.7 mm (0.11 inch) in order to obtain backlash. Use the following procedure to obtain the backlash:    
1. Prevent the pinion from rotating with an appropriate threaded fixture (1) .
2. While you set the backlash, tighten the fixture to the maximum of
7 N m (62 lb in).
3. Remove the fixture.
4. Check the backlash after removing end clearance in the bearing assembly, the backlash must be
0.20 to 0.42 mm (0.008 to 0.017 inch).
5. Measure the backlash on three equally spaced teeth.
6. Teeth spacing should not more than
0.15 mm (0.006 inch).
11     12     0S-1897 Bolt     Torque to
475 60 N m (350 44 lb ft).    
12     4     1D-4601 Bolt     Torque to
270 40 N m (199 30 lb ft).    ReferenceRefer to the Disassembly and Assembly, "Bevel and Transfer Gears - Assemble" for procedure to adjust the end play for the lower transfer gear and for the upper transfer and pinion gear.