AVSPARE.COM
parts catalog

PLATE AS-LH 1400050 - Caterpillar



1400050 PLATE AS-LH Caterpillar parts PLATE
Rating:
11
Alternative (cross code) number:
CA1400050
140-0050
1400050
Caterpillar 1400050 PLATE AS-LH

Buy PLATE AS-LH 1400050 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

START BY:a) remove wheel spindle and wheel spindle housings
Do not remove the pin that holds the wheel lean cylinder and the wheel lean bar until the lock pin has been installed. Personal injury could be the result if the wheel moves when the wheel lean cylinder is disconnected from the wheel lean bar and wheel lean arm.
1. Install the lockpin in the wheel lean bar and the front axle. 2. Remove bolt (2) and retainer (3) from each end of the pin. Remove the nuts, washers, and bolts (1). Remove the lock. Remove the pin from the wheel lean cylinder and the wheel lean arm.
Earlier Model Shown3. Remove plug (5) from each side of the front axle with tool group (A). Remove the nut, washer and bolt (4). Remove the lock. Later models do not have plug (5). On later models, remove the bolt and two washers from each end of the pin.4. Fasten a hoist to the wheel lean arm. Remove the pin from the front axle and the wheel lean arm. Remove wheel lean arm (6). Weight is 95 lb. (43 kg). 5. Remove the bearings and seals (7) from the front axle with tooling (B).Install Wheel Lean Arms
1. Lower the temperature of bearing (1). Use tooling (B) to install the bearings in axle (3). Install the bearings so they are .220 .016 in. (5.60 0.41 mm) from the inside face of the axle.2. Use tooling (B) to install lip type seals (2) in the axle. Install the seal with the lip out as shown. 3. Fasten a hoist to wheel lean arm (4). Put it in position on the axle. Install the pin that holds the wheel lean arm to the axle. Make sure the groove in the pin is in alignment with the opening in the wheel lean arm. The weight of the wheel lean arm is approximately 95 lb. (43 kg). 4. Put lock (9) in position in the wheel lean arm. Install bolt (6), washer and nut that hold it. Tighten bolt (6) to a torque of 515 20 lb.ft. (698 27 N m). Install plug (10) in each side of the axle with tooling (C). Later models do not have a plug. On later models install the two washers and the bolt on each end of the pin.5. Put wheel lean arm in position between wheel lean cylinder (5) and wheel lean bar (7). Install pin (8) that holds the three parts. Make sure the groove in the pin is in alignment with opening in the wheel lean arm. 6. Install the lock that holds pin (8). Install bolts (11), washers and the nuts that hold the lock. Tighten bolts (11) to a torque of 185 10 lb.ft. (251 14 N m).7. Put retainers (12) in position on each end of pin (8). Install the bolts that hold the retainers to the pin. Shims must be used between the retainer and pin (8) at each


Parts plate Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.