PLATE & FILM GP 1400115 - Caterpillar

Removal Procedure
Hydraulic oil pressure can remain in the hydraulic system on this machine after the engine and pump have been stopped. Serious injury can result if this pressure is not released before any service is done on the hydraulic systems. In order to prevent possible injury, release the hydraulic system pressure before working on any fitting, hose, or hydraulic component.Lower all attachments to the ground before service is started. If the hydraulic system must be serviced, tested, or adjusted with the attachment in the raised position, the attachments and lift cylinders must be supported properly.Always move the machine to a location away from the travel of other machines. Be sure that other personnel are not near the machine when the engine is running and tests or adjustments are being made.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Open the engine enclosure.
Turn the battery disconnect switch to the OFF position.
Illustration 1 g03413592
Remove cover (1).
Illustration 2 g03413593
Remove bolts (2) reposition cover (3).
Illustration 3 g03413594
Disconnect harness assemblies (4) and remove cover (3).
Illustration 4 g03413673
Disconnect hose assemblies (5) and cut cable straps (6).
Illustration 5 g03413674
Remove bolt (7) and remove metering pump (8). Installation Procedure
Install metering pump (8) in the reverse order of removal.