PLATE-WEAR 1424503 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     185-3630     Strap Wrench As     1    
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Illustration 1 g01363457
Remove plate (1) .
Illustration 2 g01363458
Close fuel shutoff valve (2) .
Illustration 3 g01363459
Open doors (4) and (3) .
Illustration 4 g01363456
Open drain valve (11) in order to drain filter assembly (9) into a suitable container for storage or disposal. Use Tooling (A) to remove filter assembly (9) .
Disconnect harness assemblies (10). Disconnect hose assembly (6). Loosen clamp (7) and disconnect hose (8) .
Remove bolts (4) and fuel priming pump (5) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     185-3630     Strap Wrench As     1    
Illustration 5 g01363456
Position fuel priming pump (5) and install bolts (4) .
Connect hose (8). Tighten clamp (7) to a torque of 3 1 N m (27 4 lb in). Connect hose assembly (6). Connect harness assemblies (10) .
Use Tooling (A) to install filter assembly (9). Close drain valve (11) .
Illustration 6 g01363459
Close doors (3) and (4) .
Illustration 7 g01363458
Open fuel shutoff valve (2) .
Illustration 8 g01363457
Install plate (1) .