PLATE 1513929 - Caterpillar

The earlier machine is shown in the photos. 1. Put tool (A) in position under guard (1) as shown. Remove the bolts and guard (1) from the machine. The weight of the guard is approximately 32 kg (70 lb.).2. Drain the oil from the engine. 3. Remove the bolt and disconnet the clip that holds breather tube (2) to the engine.4. Loosen clamps (3) and remove breather tube (2) from the engine. 5. Loosen nuts (7) and (4) and remove tubes (5) and (6) from the engine. 6. Remove eight nuts (8) and the bolts that hold the rear axle housing and support (10) to the machine. 7. Install eight 12" long guide bolts (9) to keep rear axle housing and support in alignment.8. Lift the rear of the machine approximately 101.6 mm (4 in.) so there is enough clearance to remove the oil pan. Install tooling (B). 9. Remove oil cooler bracket (11) from the oil pan and the cooler. 10. Remove the bolt, nut and breather bracket (12) from the oil pan. 11. Remove bolts (13) and oil pan (14) from the engine.Install Oil Pan
1. Inspect the oil pan gasket and make a replacement if necessary. 2. Put oil pan (14) in position and install bolts (13) that hold it. 3. Install breather bracket (12) on the oil pan. 4. Install oil cooler bracket (11) to the oil pan and the cooler.5. Lift the rear of the machine and remove tool (B). 6. Remove guide bolts (9) and install the bolts and nuts (8) that hold the rear axle and support (10) to the machine. Tighten the bolts to a torque of 475 50 N m (350 37 lb.ft.). 7. Install tube assemblies (5) and (6) on the engine as shown, with nuts (4) and (7). 8. Install breather tube (2) on the breather as shown. Tighten clamps (3). 9. Use tool (A) to install guard (1) as shown.10. Fill the engine with clean oil to the correct level. See the Maintenance Guide.