PLATE-PORT 1643256 - Caterpillar

Illustration 1 g01230719
(1) Tighten the ten bolts to a torque of 125 20 N m (90 15 lb ft) and then turn an additional 120° 10°. (2) Rubber toric seals and all surfaces in contact with seals must be clean and dry at assembly. Apply a thin layer of oil on the surfaces of the metal seals that are in contact just before installation. Seal rings must be assembled square with the bore. Toric seals must not bulge. Toric seals must not twist. (3) Torque for the six bolts ... 105 20 N m (80 15 lb ft) (4) Torque for the three bolts ... 105 20 N m (80 15 lb ft) (5) Shaft Outside diameter of shaft ... 59.38 0.01 mm (2.338 0.0004 inch) (6) Bearing sleeve Outside diameter of the bearing sleeve ... 74.885 0.013 mm (2.9480 0.0005 inch) Thickness of the bearing sleeve ... 7.720 0.013 mm (0.3040 0.0005 inch) (7) Torque for the three bolts ... 30 7 N m (22 5 lb ft) (8) Gear Inside diameter of the gear ... 75.000 0.013 mm (2.9527 0.0005 inch)