PLATE & FILM GP 1728079 - Caterpillar

Illustration 6 g00102219
(7) O-ring
Inspect the cover and O-ring (7). If either part is damaged, replace the part.
Inspect the filter cartridge for debris and for damage. If necessary, replace the filter cartridge.
Remove the filter element. Perform Step 6.a through Step 6.f in order to remove the filter element.
Illustration 7 g00104507
(4) Plug
(8) Plate
(18) O-ring
Make sure that plug (4) is removed. Make sure that all of O-ring (18) is removed from plate (8).
Illustration 8 g00918893
(8) Plate
(9) Spiral retaining ring
Remove spiral retaining ring (9).
Illustration 9 g00104510
(8) Plate
(10) Shell
(11) O-ring
(12) Filter element
Hold the filter cartridge with one hand. Grasp the grip of plate (8) with your other hand. Lift plate (8) in order to separate plate (8) from the filter cartridge.
Remove O-ring (11) from plate (8).
Lift filter element (12) from shell (10).
Pour the remaining oil into a suitable container. Note: Dispose of used oil according to local regulations.
Repeat Step 6.a through Step 6.f for the other filter groups.
Clean the shell of the filter cartridge. Perform Step 7.a through Step 7.d in order to clean the shell of the filter cartridge.
Illustration 10 g00104511
(13) Slide plate
(14) Pads
(15) Screws
(19) Port
Turn shell (10) upside-down.
Remove screws (15).
Remove Pads (14) from slide plate (13).
Wash the following parts in a clean nonflammable solvent: plug (4), plate (8), spiral retaining ring (9), shell (10) and Pads (14). Dry the parts.
Install the filter elements. Perform Step 8.a through Step 8.k in order to install the filter elements. Note: Consult a Caterpillar dealer for the Service Kit that is needed to install the filter element and the filter cartridge.
Apply spray type oil to the inside of shell (10) in order to prevent rust.
Apply grease to a new O-ring (11).
Plate (8) will contact the inside of shell (10). Apply grease to this point.
Apply grease to O-rings inside ports (19) at the bottom of shell (10).
Install new Pads (14). Tighten the screws to a torque of 0.4 N m (3.5 lb in).
Apply spray type oil into the clearance between shell (10) and slide plate (13).
Illustration 11 g00104512
(8) Plate
(10) Shell
(16) Boss
(17) Notch
Turn over shell (10). Apply grease to the two O-rings on new element (12). Install element (12) into shell (10).
Move boss (16) in alignment with notch (17). Install plate (8) into shell (10).
Install spiral retaining ring (9) into the groove in shell (10).
Apply grease to new O-ring (18). Install O-ring (18) on plug (4).
Install plug (4) into plate (8).
Install the filter cartridge. Perform Step 9.a through Step 9.e in order to install the filter cartridge.
Illustration 12 g02515259
(F) Port
(G) Slide plate
Check that ports (F) at the bottom of the filter case are closed. Note: If the ports are open, rotate slide plate (G) counterclockwise