PLATE 1749533 - Caterpillar

Illustration 4 g06228737
Use conveyor buttons (7) to center the conveyor.
Use propel lever (1) to center the front tracks.
Illustration 5 g06229133
Observe level indicator (8). If the indicator shows "0" go to Step 14. If the indicator does not show "0", go to Step 12.
Illustration 6 g06229150
Use rear leg height switches (9) and (10) to level the rear of the machine. Level indicator (8) will show "0" when the rear of the machine is level. Make sure that the rotor does not contact the ground during this step.
Illustration 7 g06229742
Use travel mode button (11) to set the machine to roading mode. The indicator next to the button illuminates when the machine is in the roading mode.
Illustration 8 g06229744
Use throttle control button (12) to operate the engine in high idle.
Illustration 9 g06229777
Monitor hydraulic oil temperature (13) on the operator display. Operate the machine until the oil temperature reaches the test temperature listed in the "Specifications" section.Test Procedure
Back up the machine far enough to reach full speed before the start line.
Illustration 10 g06229780
Press interlock button (14) on propel lever (1) to activate propel system. Move the propel lever to the full forward position to accelerate the machine. Hold the lever in the full forward position.Note: The parking brake will release automatically.
Illustration 11 g06229846
Monitor machine speed (15) on the display. The indicated machine speed will increase until maximum propel speed is achieved. Refer to the "Specifications" section for the maximum propel speed.Note: When maximum speed is achieved, the propel lever can be returned to the center position. Machine speed should remain constant.
Use Tool (A) to time the machine through the 30.5 m (100 ft) course. Refer to the "Specifications"