PLATE-WEAR 1844426 - Caterpillar

Do not tilt the cab when occupied. Before tilting the cab remove all loose articles from the cab, secure all windows and emergency exits, and then close the cab and cab riser doors. Failure to do so can result in personal injury or damage to the machine.
Illustration 1 g00736779
(1) Cab retention bolts (2) Washers (3) Weld nuts
Illustration 2 g00960205
The switch for the cab tilt control is located inside the left rear access door for machines with (S/N: BPHCAMCBY).The switch for the cab tilt control is located inside the left front access door for machines with (S/N: M2HLARC3R). This model is pictured. Lower
Remove the cab retention bolts (1) and washers (2) from the rear of the cab riser compartment and install the cab retention bolts and washers in the weld nuts (3) .
Illustration 3 g00960206
Push the switch for the cab tilt control (A) .Note: When the switch for the cab tilt control is held down, the cab will move to the LOWER position.
After making sure that the cab is in the desired position or the cable is tight, release the switch.
Turn the battery disconnect switch to the OFF position and remove the disconnect switch.Raise
Illustration 4 g00960208
Push the switch for the cab tilt control (B) .Note: When the switch for the cab tilt control is held down, the cab will move to the RAISE position.
After making sure that the cab has moved to the highest position, release the switch.
Remove cab retention bolts (1) and washers (2) from weld nuts (3) .
Install cab retention bolts (1) to a torque of 800 100 N m (590 75 lb ft).