PLATE-FUSE 1905442 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-2320 Combination Puller 1
B 230-7923 Spanner Wrench As 1
C 2P-8312 Retaining Ring Pliers 1
D 129-1938 Grease Cartridge 1
Illustration 1 g01023136
Use two people to install knuckle (17). The weight of knuckle (17) is approximately 50 kg (110 lb).
Illustration 2 g01379622
Apply Tooling (D) to pin assemblies (13) and (15). Install pin assembly (15) and bolts (16). Tighten bolts (16) to a torque between 255 N m (188 lb ft) and 315 N m (232 lb ft). Install pin assembly (13) without shims (14). Install bolts (12). Do NOT torque bolts (12) at this time.
Illustration 3 g01379613
Remove wheel flange (10) and bearing cone (11).
Illustration 4 g01023088
Install ring gear assembly (9).
Illustration 5 g01379521
Use Tooling (B) to install spanner nut (3). Tighten spanner nut (3) to a torque of 1000 50 N m (737 36 lb ft). Install locking plate (4) and bolts (5).
Illustration 6 g01023074
Illustration 7 g01023075
Use a suitable pry bar and push the double U-joint toward the wheel flange. This will make the installation of retaining ring (8) easier. Install washer (6) and thrust washer (7). Use Tooling (D) and install retaining ring (8).
Illustration 8 g01029956
Use a suitable pry bar to move the knuckle up and down. Measure the end play. The end play should be between 0.4 mm (0.016 inch) and 0.6 mm (0.024 inch). Remove bolts (12) and pin assembly (13). Add shims (14), as required. Tighten bolts (12) to a torque between 255 N m (188 lb ft) and 315 N m (232 lb ft).
Illustration 9 g01032913
Connect tie rod end (1) and tighten nut (2) to a torque of 250 N m (185 lb ft).End By:
Install the final drive planetary. Refer to Disassembly and Assembly, "Final Drive Planetary - Install".