1907070 PLATE AS Caterpillar parts
330C, 330C L, 330C MH
Rating:
Alternative (cross code) number:
CA1907070
190-7070
1907070
CA1907070
190-7070
1907070
Weight: 56 pounds 25 kg.
EXCAVATOR, MOBILE HYD POWER UNIT,
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
$129.22
30 Apr 2020
-: -
Lenox CP 16 6X1 1/4 .042 3/4 VPVREHS (1907070)
Number on catalog scheme:
8
For full view, you need register
Compatible equipment models: 1907070:
Information:
Illustration 1 g01209056
Rear axle cooling fan solenoid connections
This diagnostic code is associated with the rear axle cooling fan (attachment) solenoid. The FMI 03 means that the ECM has determined that the voltage of the solenoid circuit is above normal.Some possible causes of the diagnostic code are listed:
The solenoid has failed.
The energize circuit of the solenoid is shorted to the +battery circuit.
The ECM has failed. This is unlikely.System Response:When the CID 0796 FMI 03 diagnostic code is active, the machine response can be:
The ECM will not control the differential cooling fan
The differential cooling fan may run at maximum speed when the key switch is ON.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0796 FMI 03 is active before performing this procedure.Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO THE +BATTERY CIRCUIT
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector from the solenoid. Disconnect the machine harness connectors J-1 and J-2 from the ECM.
At the machine harness ECM connector J2, measure the resistance from contact J2-1 (wire C411-OR(Orange)) to all J-1 and J-2 contacts that are connected to +battery. The J-1 +battery contacts are J1-1, J1-6, J1-28 and J1-40. No J-2 contacts are connected to +battery. Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J2-1 (wire C411-OR(Orange)) and the circuit that has a low resistance measurement. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK IF THE DIAGNOSTIC CODE IS STILL ACTIVE
Inspect the contacts of the
Caterpillar parts catalog:
Parts plate Caterpillar catalog:
311C, 311D LRR, 311F LRR, 312C, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315C, 315D L, 316E L, 318B, 318C, 318D...
1290T, 1390, 2491, 2590, 307C, 307D, 307E, 308C, 308D, 308E, 308E CR, 308E SR, 308E2 CR, 311D LRR, 311F LRR, 312C, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314D CR...
225, 227, 235, 235B, 235D, 245, 320B FM LL, 325B L, 325C, 330B L, 330C L, 5130, 5130B, 5230, 5230B, 539, 621E, 621F, 621G, 623E, 623F, 623G, 627E, 627F, 627G, 631E, 631G, 633E II, 637E, 637G, 69D, 769...
225, 227, 235, 235B, 235D, 245, 320B FM LL, 325B L, 325C, 330B L, 330C L, 5130, 5130B, 5230, 5230B, 539, 621E, 621F, 621G, 623E, 623F, 623G, 627E, 627F, 627G, 631E, 631G, 633E II, 637E, 637G, 69D, 769...
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 330C, 330C FM, 330C L, 330C MH, 345B II, 345B II MH, 511, 521, 521B, 522, 522B, 532, 541, 541 2, 551, 552, 552 2, 631E, 631G, 637E, 637G, ...
12H, 140H, 14H, 16H, 330C, 330C FM, 330C L, 330C MH, 621G, 623G, 627G, 631E, 631G, 637E, 637G, 725, 730, 735, 735B, 740, 740B, 844K, 938G, 950G, 990K, 993K, D10N, D10R, D10T, D250E II, D300E II, D350E...
1290T, 1390, 2491, 2590, 325D FM, 325D FM LL, 330, 330 FM L, 330B L, 330C, 330C FM, 330C L, 330C MH, 330D FM, 330D L, 330D MH, 336D L, 336D LN, 340D L, 340D2 L, 345B, 345B II, 345B II MH, 345B L, 345C...
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 324E, 324E L, 324E LN, 325C, 325C FM, 325D, 325D FM, 325D FM LL, 325D L, 325D M...
1090, 1190, 1190T, 1390, 2290, 2390, 2391, 320 L, 320B, 320B FM LL, 320C, 320C FM, 320D, 320D FM, 320D FM RR, 322B L, 322C, 322C FM, 323D LN, 323D SA, 323E L, 324D FM, 324D FM LL, 325, 325 L, 325B, 32...
320B, 320C, 320C FM, 320D, 320D FM, 320D FM RR, 322B L, 322C, 322C FM, 323D LN, 323D SA, 323E L, 324D, 324D L, 324D LN, 324E, 324E L, 324E LN, 325, 325 L, 325 LN, 325B, 325B L, 325C, 325C FM, 325D, 32...
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 330C, 330C FM, 330C L, 330C MH, 345B II, 345B II MH, 511, 521, 521B, 522, 522B, 532, 541, 541 2, 551, 552, 552 2, TK1051, TK711, TK721, TK...
330C, 330C FM, 330C L, 330C MH
1907060
PLATE AS
330C, 330C L, 330C MH
330C, 330C L, 330C MH
1907056
PLATE AS
330C, 330C L
330C, 330C L
3187917
PLATE-MOUNTING
Caterpillar
Caterpillar
3290843
PLATE AS
Caterpillar
Caterpillar
3241987
PLATE-SUPPORT
Caterpillar
Caterpillar
3241986
PLATE-SUPPORT
Caterpillar
Caterpillar
1936655
PLATE
330C, 330C L, 330D L, 345C, 349E, 349E L, 349E L VG, 349F L
330C, 330C L, 330D L, 345C, 349E, 349E L, 349E L VG, 349F L
2459713
PLATE
330C, 330C L
330C, 330C L
1348857
PLATE AS
328D LCR, 330B, 330B L, 330C, 330C FM, 330C L, 330D, 330D L, 336D, 336D2, 336E L, 340D L
328D LCR, 330B, 330B L, 330C, 330C FM, 330C L, 330D, 330D L, 336D, 336D2, 336E L, 340D L
2402895
PLATE AS
330C, 330C L
330C, 330C L
1907068
PLATE AS
330C, 330C L, 330C MH
330C, 330C L, 330C MH
1907072
PLATE AS
330C, 330C L, 330C MH
330C, 330C L, 330C MH