PLATE 1935893 - Caterpillar

1. The crankcase oil level dipstick is located under the engine hood on the engine. Unlatch and raise the engine hood. 2. Remove the dipstick to measure the oil level.After thoroughly removing oil on the dipstick, reinsert and pull it out again. The oil level must be between the FULL and ADD marks on the dipstick.Badly contaminated or deteriorated oil should be replaced early regardless of the replacement interval. 3. Remove the oil fill plug and add oil if necessary.4. Clean and install the fill plug.5. Close and latch the engine hood.Hydraulic Oil
Check the HYDO Oil Level
Never remove the cap from the implement hydraulic tank if the oil is hot. Air can enter the system and cause pump damage.
1. The hydraulic oil tank is located on the right side of the machine.2. To measure the hydraulic oil level, place the machine on level ground and lower the bucket to the ground with the stick vertical, as shown above.3. Unlatch and open the side cover at the right of the machine. 4. Maintain the oil level in the low temperature range for a cold machine and in the high temperature range for a machine at normal operating temperature. 5. Open the pressure cap slowly to relieve any pressure.6. Close the pressure cap.7. Close and latch the side cover. 8. Remove the fill plug.9. Add oil if necessary.10. Clean and install the fill plug.Cooling System
Check the Coolant Level
1. Unlatch and raise the engine hood. 2. Unlatch and open the radiator side cover. 3. Coolant level should be between the marks on the coolant reservoir.4. If additional coolant is needed, remove the coolant fill cap of the coolant reservoir and add coolant as necessary. 5. If the coolant reservoir is emptied, add coolant to the radiator. To do this, slowly loosen the fill cap of the radiator to release pressure. 6. Inspect the condition of the cap gasket. Replace the cap gasket if necessary.7. Install the radiator cap.8. Close and latch the radiator side cover and engine hood.Fuel Tank
Drain the Water and Sediment
1. Dispose of drained material according to local regulations.2. Open the drain valve located under the fuel tank and allow the water and sediment to drain into a container.3. Close the drain valve.Fill Fuel Tank
Fuel can be added to the tank by removing fuel fill cap on top of tank.After completion of refueling, be sure to lock the fuel tank cap to protect against vandalism.Walk - Around Inspection
Inspect Machine
1. Inspect the implements for damage or excessive wear. Repair if damaged.2. Inspect implement cylinders and linkage for damage or excessive wear. Repair if damaged. 3. Inspect and replace lights, broken bulbs and lenses. 4. Use commercially available window cleaning solutions to clean the windows. 5. Inspect and remove any trash build-up in and around the engine.6. Inspect and repair any cooling system or engine component leaks. 7. Check the air filter restriction indicator. If the indicator is in the red zone, service the engine air filter.After servicing, push the