PLATE-CLAMP 1947205 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
D 1P-0510 Driver Group 1
E 138-9299(1) Oil Seal Tool 1
F 139-0088(1) Seal Tool 1
FT-3171(2) Seal Installer 1
(1) Use with a 19.1 mm (0.75 inch) shaft
(2) Use with a 25.4 mm (1.00 inch) shaft
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01385853
Clean water pump shaft (6) and the counterbore for lip seal (9) in housing (1).
Use Tooling (D) to install a new lip seal (9) in housing (1).Note: Install the seal with the part number on the metal face of the seal toward the housing. Ensure that the lip seal is flush with the front edge of the counterbore of the housing. Do not lubricate the lip seal. Use a press to install the lip seal. Do not install the lip seal by hand.
Install bearing assembly (8) on water pump shaft (6).
Place retainer (5) with “OUTSIDE” markings toward the gear end of water pump shaft (6).
Use a suitable press and install gear (2) on water pump shaft (6).Note: Install gear (2) against bearing assembly (8).
Slide Tooling (E) over shaft (6). The tapered edge will be facing outward.
Install gear (2) and the water pump shaft into housing (1). Use care not to damage lip seal (9). Install bolts (3) that hold bearing retainer (5) to the housing.
Remove Tooling (E) from water pump shaft (6).
Use a press and Tooling (F) to install a new seal group (7) over water pump shaft (6) and into housing (1). Ensure that the outer shell of the seal is fully seated in the housing.
Put impeller (4) in position on water pump shaft (6). Use a suitable press and install impeller (4) on the water pump shaft.Note: Install impeller (4) within 0.00 0.25 mm (0.000 0.010 inch) of the end of the water pump shaft.
Install O-ring seal (10) on the housing.End By:
Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".