PLATE-CLUTCH 1T1897 - Caterpillar

ATA (American Trucking Association) Data LinkA two-wire electrical connection for communication with other microprocessor based devices that are compatible with the American Trucking Association and SAE Standards (J1587 and J1708) such as trip recorders, electronic dashboards, powertrain controls, and maintenance systems. The Data Link is also the serial communication medium used for programming and troubleshooting with Caterpillar devices.Active Diagnostic CodeDescribes a condition that is currently present to alert the driver or service technician of an abnormal engine operation parameter. Refer to Diagnostic Fault Code.Aftermarket DeviceAs used here, a device or accessory installed by the customer or vehicle OEM after the engine is delivered.Air-To-Air Aftercooler (ATAAC)A means of cooling intake air after the turbocharger, using ambient air for cooling. The intake air is passed through an aftercooler (heat exchanger) mounted in front of the radiator before going to the intake manifold.Alternating Current (AC)The direction of current flow changes (alternates) regularly and constantly in a circuit.American Wire Gauge (AWG)A measure of the diameter (and therefore the current carrying ability) of electrical wire. The smaller the AWG number, the larger the wire.Before Top Center (BTC)The 180 degrees of crankshaft rotation before the piston reaches the very top of its travel (normal direction of rotation).Boost Pressure SensorThis sensor measures inlet manifold air pressure and sends a signal to the ECM.Bypass CircuitA circuit, usually temporary, to substitute for an existing circuit, typically for test purposes.CalibrationAs used here, is an electronic adjustment of a sensor signal.Caterpillar Engine MonitoringThe part of the Caterpillar Electronic Engine Control that monitors Coolant Temperature to alert the operator of detected problems. The Coolant Temperature Sensor is supplied by Caterpillar and monitored by the ECM. After market engine monitoring systems do not interface with the Caterpillar Electronic Engine Control.Check Engine LampSometimes referred to as the "Diagnostic Lamp", it is used to alert the operator of the presence of an active event and is used to flash a diagnostic code.Clutch SwitchThis OEM supplied and installed switch is typically a limit switch mounted near the pedal and is usually adjustable. This switch is normally closed with the pedal released. Depressing the clutch will open the circuit.CodeRefer to Diagnostic Fault Code and Diagnostic Event Code.Cold ModeA mode of engine operation where the timing is retarded and the low idle may be raised for engine protection, reduced smoke emissions and faster warm up time.Coolant Temperature SensorThis sensor detects the engine coolant temperature for Cold Mode operation and Caterpillar Engine Monitoring (if Engine Monitoring is not programmed OFF).Cruise Control RangeThe range that the cruise control can operate within. Usually limited to the speed range anticipated on the open road. It is programmable using the Low Cruise and High Cruise Limits.Customer Specified ParameterA parameter value that can be changed and whose value is set by customer. Protected by Customer Passwords.Data LinkRefer to ATA Data Link.Desired RPMAn input to the electronic governor within the ECM. The electronic governor uses inputs from the Throttle Position Sensor, Engine Speed/Timing Sensor and Customer Parameters to determine "Desired RPM". Diagnostic Event