PLATE-YOKE- 1U8847 - Caterpillar

Illustration 1 g06054878
Typical example
Table 1
Item Qty Part Specification Description
All bores must be free of paint. Use 5P-0960 Grease Cartridge in order to coat all bores for the pins, the bucket, and the cylinder pin bores.
1 - - Assemble the stick cylinder so that the grease zerk is directed, as shown.
2 1 4I-4811 Pin As Diameter is 69.850 0.025 mm (2.7500 0.0010 inch).
3 1 4I-4809 Pin As Diameter is 79.850 0.025 mm (3.1437 0.0010 inch).
4 2 166-1495 Lip Type Seal Lubricate the sealing lip lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces outside, as shown. Install lip type seals so that the lip type seals do not extend beyond the face of the boss.
5 2 235-7679 Lip Type Seal Lubricate the sealing lip lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces outside, as shown. Install lip type seals so that the lip type seals do not extend beyond the face of the boss.
6 2 166-1494 Lip Type Seal Lubricate the sealing lip lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces outside, as shown. Install lip type seals so that the lip type seals do not extend beyond the face of the boss.
7 2 489-3008 Bushing (1) Bore before assembly is 90.21 0.04 mm (3.552 0.002 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
8 2 229-1096 Bushing (1) Bore before assembly is 70.17 0.04 mm (2.76 0.002 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
9 2 489-3010 Bushing (1) Bore before assembly is 80.20 0.04 mm (3.157 0.002 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
(1) Assemble bearing so that end surface with groove faces the inside