PLATE 2045093 - Caterpillar

Oil Filter Differential Pressure
The ECM automatically warns the operator of high oil filter differential pressure. The default settings that are programmed at the factory are listed in Table 8.
Table 9
Oil Filter Differential Pressure    
Parameter     Default Setting    
Warning setpoint    
105 kPa (15 psi)    
Warning delay     5 seconds    
Hysteresis    
10 kPa (1.5 psi)    
Security level     No required password    If the oil filter differential pressure is above 105 kPa (15 psi) for 5 seconds, a warning will occur. To deactivate the warning, the oil filter differential pressure must be below 95 kPa (13.5 psi).Fuel Filter Differential Pressure
The ECM automatically warns the operator of high fuel filter differential pressure. The default settings that are programmed at the factory are listed in Table 10.
Table 10
Fuel Filter Differential Pressure    
Parameter     Default Setting    
Warning setpoint    
70 kPa (10 psi)    
Warning delay     5 seconds    
Hysteresis    
10 kPa (1.5 psi)    
Security level     No required password    If the fuel filter differential pressure is above 70 kPa (10 psi) for 5 seconds, a warning will occur. To deactivate the warning, the fuel filter differential pressure must be below 60 kPa (8.7 psi).Crankcase Pressure
The ECM will automatically perform the following functions if high crankcase pressure occurs:
Warning
Derating
Shut downThe default settings that are programmed at the factory are listed in Table 11.
Table 11
Crankcase Pressure    
Parameter     Default Setting    
Warning setpoint    
2 kPa (.3 psi)    
Warning delay     3 seconds    
Derate setpoint    
6 kPa (.9 psi)    
Derate delay     10 seconds    
Maximum time of derating     480 seconds    
Hysteresis    
0.25 kPa (.036 psi)    
Security level     Required password    
Maximum derating     15%    
Shutdown setpoint    
3.5 kPa (.51 psi)    
Shutdown delay     3 seconds    If the crankcase pressure is above 2 kPa (.3 psi) for 3 seconds, a warning will occur. To deactivate the warning, the crankcase pressure must be below 1.75 kPa (.254 psi).If the crankcase pressure is above 6 kPa (.9 psi) for 10 seconds, a derating will occur. The continuous schedule of the derating will reach 15 percent in 480 seconds.When the crankcase pressure is less than 5.75 kPa (.39 psi), the percent of the derating is decreased until full power is restored. However, if the crankcase pressure rises above the setpoint again, the derating resumes.If the crankcase pressure is above 3.5 kPa (.51 psi) for 3 seconds, a shutdown will occur.Note: The default settings result in a shutdown that occurs before a derating. These settings were selected for the reason that high crankcase pressure can occur rapidly. The settings can be reprogrammed.Aftercooler Coolant Temperature
Note: The following information concerns engines with separate circuit aftercooling. For engines with jacket water aftercooling, monitoring of the aftercooler coolant temperature is disabled. However, the jacket water coolant temperature is monitored for all engines.The ECM will automatically perform the following functions when high aftercooler coolant