AVSPARE.COM
parts catalog

PLATE 2057844 - Caterpillar


2057844 PLATE Caterpillar parts
Rating:
66
Alternative (cross code) number:
CA2057844
205-7844
2057844
Caterpillar 2057844 PLATE
Weight: 16 pounds 7 kg.

Buy PLATE 2057844 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Personal injury or death can result from sudden machine movement.Sudden movement of the machine or release of air pressure or oil pressure can cause injury to persons on or near the machine.To help prevent possible injury before testing and adjusting any air system or hydraulic system, perform the procedure in the Testing and Adjusting, "General Information" section.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Table 1
Tools That Are Required    
8T-0857 Pressure Gauge    
Illustration 1 g00664059
View of the Brake Control (1) Pressure port for the service brake pressure.Service Brake Pedal
Illustration 2 g00458021
Service Brake Valve (2) Shims.
Install a 0 to 10000 kPa (0 to 1450 psi) pressure gauge at pressure port (1) .
Start the engine and permit the oil pressure to rise to the cut-out pressure for the accumulators.
Fully push the service brake pedal and check the reading on the pressure gauge. When the service brake pedal is depressed, the correct brake pressure is 8600 345 kPa (1250 50 psi).
Stop the engine.
As required, install shims (2) or remove shims (2) if the pressure is not within this range. One shim will change the pressure by approximately 90 kPa (13 psi).
Remove the pressure gauge.Left Pedal
Use the left pedal and perform Steps 1 through 4.When the left pedal is depressed, the correct brake pressure is 6200 345 kPa (900 50 psi).


Parts plate Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.