PLATE AS 2061632 - Caterpillar

Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Install caps and plugs on all openings in order to prevent dirt or debris from entering the system. Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: For easier assembly, mark all hose assemblies, tube assemblies, wire harnesses and cables for identification purposes.
Illustration 1 g00588023
The view is under the cab.
Disconnect tube assembly (1) from steering neutralizer valve (2) .
Disconnect hose assembly (3) from steering neutralizer valve (2) .
Disconnect tee (4) from steering neutralizer valve (2) .
Remove two bolts (5) and the washers that secure steering neutralizer valve (2) to the plate assembly. Remove steering neutralizer valve (2) from the plate.
Sudden release of spring force can cause injury.To prevent the possibility of injury, follow the procedure to relieve the spring pressure.
Illustration 2 g00588538
Remove boot (6) from steering neutralizer valve (2). Remove stem (7), spring (8), O-ring seal (9), and adapter (10) from steering neutralizer valve (2) .
Illustration 3 g00588539
Remove lip seal (11) from steering neutralizer valve (2) .Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1P-0510     Driver Group     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Verify that all of the components of the steering neutralizer valve are clean and free of foreign material prior to installation.Note: Check all of the O-ring seals and the components for wear or damage. Replace the components, if necessary. Lubricate the O-ring seals lightly with the lubricant that is being sealed.
Illustration 4 g00588540
Use Tooling (A) and a hammer to install lip seal (11) (not shown). Lubricate lip seal (11) (not shown) lightly with the lubricant that is being sealed.
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Illustration 5 g00588538
Install stem (7), spring (8), O-ring seal (9), and adapter (10) to steering neutralizer valve (2). Install boot (6) to steering neutralizer valve (2) .
Illustration 6 g00588023
The view is under the cab.
Position steering neutralizer valve (2) to the plate. Install two bolts (5) and the washers that secure steering neutralizer valve (2) to the plate assembly.
Connect tee (4) to steering neutralizer valve (2) .
Connect hose assembly (3) to steering neutralizer valve (2) .
Connect tube assembly (1) to steering neutralizer valve (2) .End By:
Charge the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System - Pressure Release/Charge".
Separate the frame lock link. Refer to Disassembly and Assembly, "Frame Lock Link - Separate and Connect".
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".