PLATE-DETENT 2062800 - Caterpillar

Illustration 41 g01293875
Install compressor insert (12) into compressor housing (11). Ensure that compressor insert (12) remains level in order to avoid damage to the impeller. Ensure that the harness assembly for the speed sensor does not get trapped.
Illustration 42 g01293889
Install bolts (13) and install the lock washers. Tighten bolts (13). Remove Tooling (C).
Illustration 43 g01293893
Tighten gland nut (16) on speed sensor (14).
Use Tooling (X) in order to measure the gap from the tip of an impeller vane to compressor insert (12). This measurement should be taken NEXT to speed sensor (14).
Illustration 44 g01293900
Use Tooling (X) in order to measure the gap from the tip of an impeller vane to compressor insert (12). This measurement should be taken at the speed sensor. If the reading is different from Step 72, adjust the speed sensor. Note: The following steps are for the installation of the housing for the turbine inlet.
Illustration 45 g01293923
Place nozzle (10) into the housing for turbine inlet (5).
Illustration 46 g01291012
Place clamping ring (9) onto the nozzle. Align the holes.
Illustration 47 g01293935
Apply Tooling (V) to capscrews (8). Install capscrews (8) and the lock washers to clamping ring (9). Tighten the capscrews to a torque of 67.0 N m (49.42 lb ft).
Illustration 48 g01293938
Install seal (7) onto the housing for turbine inlet (5).
Illustration 49 g01293939
Use a suitable lifting device in order to place the housing for turbine inlet (5) on gas outlet housing (24). The weight of the housing for turbine inlet (5) is approximately 35 kg (77 lb).
Illustration 50 g01293945
Use the spacers and nuts (6) in order to fasten the housing for turbine inlet (5) to gas outlet housing (24).
Illustration 51 g01290972
Install insulation (4).
Illustration 52 g01290961
Insert cotter pins (3) in latches (2) that hold the insulation in place. Note: The following steps are for the installation of the turbocharger on the engine.
Use a suitable lifting device in order to place the turbocharger into position on the engine. Note: When you are positioning the turbocharger, ensure that the turbocharger remains level. Ensure that the O-ring seals for the oil system are not trapped.
Install the main bolts in the mounting foot. Tighten the bolts to a torque of 420 N m (310 lb ft). Use Tooling (C).
Install the main mounting bolts with Tooling (A).
Connect the connections to the housing for the turbine inlet.
Connect the speed sensor connection.
Connect the turbocharger wash group, if equipped.
Reconnect the instrumentation.
Connect the oil system if the oil is supplied externally. Note: The turbocharger must be filled with oil prior to operation on the engine. After installation of the turbocharger on the engine, fill the turbocharger with clean engine oil at the oil supply port. Connect the oil supply line after filling.