PLATE AS 2230591 - Caterpillar

Illustration 7 g06169623
(5) Clamp
(6) Hose from main control valve to hydraulic oil cooler
(7) Hose from hydraulic tank to hydraulic oil cooler
Loosen clamp (5), and move hose (6) and hose (7) toward the rear of the machine.
Illustration 8 g06169636
(6) Hose from main control valve to hydraulic oil cooler
(7) Hose from hydraulic tank to hydraulic oil cooler
(8) Hose
(9) 6V-9831 Cap As
(10) 260-9189 Swivel Elbow Assembly
(11) 153-6256 Elbow As
(12) 517-4752 Hose As
(13) 148-8357 Elbow As
(14) 148-8429 Tee As
(15) 9x-6579 Orifice Nut
(16) 150-3071 Reducer As
(17) 148-8357 Elbow As
(18) 521-1039 Bypass Valve
(19) 148-8429 Tee As
Illustration 9 g06170069
Orientation of 521-1039 Bypass Valve (18) with 260-9189 Swivel Elbow Assembly is 30°. (View from top)
Illustration 10 g06170075
Orientation of 148-8357 Elbow As with 521-1039 Bypass Valve is 54°. (View from side)
Illustration 11 g06170099
Orientation of 148-8357 Elbow As with 521-1039 Bypass Valve is 10°. (View from bottom)
Illustration 12 g06172892
View from top
(11) 153-6256 Elbow As
Orientation of 153-6256 Elbow As (11). Parallel to machine forward direction.
Illustration 13 g06169623
(5) Clamp
(6) Hose from main control valve to hydraulic oil cooler
(7) Hose from hydraulic tank to hydraulic oil cooler
Adjust hose (6) and hose (7). Tighten clamp (5).
Fill the hydraulic tank. Refer to Operation and Maintenance Manual , SEBU9442 , Hydraulic System Oil - Change for instructions.
Illustration 14 g06170104
Replace sheet (4) and the bulk seal.
Illustration 15 g06170118
(1) 8T-4189 Bolt
(2) 5P-4116 Hard Washer
(3) 8T-4908 Bolt
Replace bolt (1) and washer (2) in three places. Replace bolt (3) and washer (2) in two places.
Illustration 16 g06165863
Hood alignment
(TT) 10 + 5 - 3 mm (0.4 + 0.2 - 0.12 inch)
(UU) 10 3 mm (0.4 0.12 inch)
Illustration 17 g06165868
Hood alignment
(19) Radiator enclosure
(VV) 12 2 mm (0.5 0.08 inch)
Correctly align radiator enclosure (19) with the gap dimensions shown in Illustration 17.