PLATE AS 2352769 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on the hose assemblies for installation purposes. Plug the hose assemblies. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g00747460
Remove four bolts (1), the washers, and center guard assembly (2) .
Illustration 2 g00747461
Remove four bolts (3), the washers, and right side guard assembly (4) .
Illustration 3 g00747462
Disconnect hose (5), (6), and (7). Remove two mounting nuts (8), and the washers. Remove brake control valve (9) .Installation Procedure
Illustration 4 g00747462
Install brake control valve (9), two mounting nuts (8), and the washers. Connect hose (5), (6), and (7) .
Illustration 5 g00747461
Install right side guard (4), four bolts (3), and the washers.
Illustration 6 g00747460
Install center guard assembly (2), four bolts (1), and the washers.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".