PLATE 2424996 - Caterpillar

Illustration 54 g01089992
Put the carrier assembly on a wood block, as shown. Use a screwdriver to compress the retainer ring. Remove gear (106) from the carrier assembly. Remove retaining ring (106A) .
Illustration 55 g01090001
Remove spiral lockring (107). Use Tooling (G) to remove bearing (108) from the carrier. Remove seal rings (108A) .
Illustration 56 g00832691
Use a hammer and a punch to push spring pin (109) from the carrier assembly.
Illustration 57 g01087333
Remove shaft (118), thrust discs (110), (113), (114) and (117), and gears (112) and (116). Remove bearings (111) and (115) from the gears. Remove pin (109) from shaft (118) .
Repeat Steps 82 and 83 for the remaining gears.
Illustration 58 g01087342
Remove gear (119) from the shaft assembly.
Remove seals (120) and (121) from the seal carrier.
Illustration 59 g00832673
Remove spiral lockring (122) from the shaft assembly.
Illustration 60 g00832651
Put shaft assembly on suitable blocks, as shown. Use a soft hammer to strike the shaft assembly (124) until the bearing is removed from the shaft assembly (123) .
Illustration 61 g00832640
Remove retaining ring (125) from the shaft assembly. Remove bearing (126) .
Illustration 62 g00832629
Use Tooling (H) and a suitable press to remove seal carrier (127) from the shaft assembly.
Illustration 63 g01088299
Use Tooling (L) to remove bearing (128) from the shaft assembly.
Illustration 64 g00832561
Remove gear (129) from the clutch housing.
Illustration 65 g00832558
Remove piston (130) from the No. 7 clutch housing.
Illustration 66 g00832555
Remove seals (131) and (132) from the piston.
Illustration 67 g00832553
Remove spiral lockring (133). Use Tooling (G) to remove bearing (134) from the housing.