PLATE 2716076 - Caterpillar

Face Runout (Axial Eccentricity) of the Flywheel
Table 1
Tools Needed    
Part Number     Part Name     Quantity    
8T-5096     Dial Indicator Gp     1    
Illustration 1 g02509960
Checking face runout of the flywheel
Refer to Illustration 1 and install the dial indicator. Always put a force on the crankshaft in the same direction before the dial indicator is read. to remove any crankshaft end clearance.
Set the dial indicator to read 0.0 mm (0.00 inch).
Turn the flywheel at intervals of 90 degrees and read the dial indicator.
Take the measurements at all four points. The difference between the lower measurements and the higher measurements that are performed at all four points must not be more than 0.13 mm (0.005 inch) runout per 25.4 mm (1.0 inch) of the diameter of the flywheel.Bore Runout (Radial Eccentricity) of the Flywheel
Table 2
Tools Needed    
Part Number     Part Name     Quantity    
7H-1942     Dial Indicator     1    
Illustration 2 g02509996
Checking bore runout of the flywheel (1) 7H-1945 Holding Rod (2) 7H-1645 Holding Rod (3) 7H-1942 Dial Indicator (4) 7H-1940 Universal Attachment
Install 7H-1942 Dial Indicator (3) . Make an adjustment of 7H-1940 Universal Attachment (4) so the dial indicator makes contact on the flywheel.
Set the dial indicator to read 0.0 mm (0.00 inch).
Turn the flywheel at intervals of 90 degrees and read the dial indicator.
Take the measurements at all four points. The difference between the lower measurements and the higher measurements that are performed at all four points must not be more than the following values for the maximum permissible face runout (radial eccentricity) of the flywheel.Flywheel ... 0.13 mm (0.005 inch)
Illustration 3 g02510080
Flywheel clutch pilot bearing bore
To find the runout (eccentricity) of the pilot bearing bore, use the preceding procedure.
The runout (eccentricity) of the bore for the pilot bearing in the flywheel must not exceed the following values:Flywheel ... 0.13 mm (0.005 inch)