PLATE AS.-SIDE 2903696 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     185-3630     Strap Wrench As     1    
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01250304
Remove bolts (1). Remove sheet (2) .
Illustration 2 g01250305
Turn valve (3) to the OFF position.
Illustration 3 g01250522
Open door (4) .
Illustration 4 g01250523
Drain the water separator (8) into a container for storage or disposal. Disconnect hose (9). Disconnect harness assembly (10) .
Use Tooling (A) in order to remove water separator (8). Remove water separator (8) .
Disconnect hose assemblies (6) .
Remove bolts (5). Remove water separator base (7) .Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 5 g01250523
Position water separator base (7). Install bolts (5) .
Connect hose assemblies (6) .
Install water separator (8).
Connect harness assembly (10). Connect hose (9) .
Purge the air from the fuel system.
Illustration 6 g01250522
Close door (4) .
Illustration 7 g01250305
Turn valve (3) to the ON position.
Illustration 8 g01250304
Position sheet (2). Install bolts (1) .