PLATE 2F2006 - Caterpillar

See Illustration 6 for above dimension references. Unless otherwise specified, tolerance is 1.5 mm (0.060 inch).
Illustration 7 g02362906
Suspension bore detail. Unless given in this illustration in mm (inch), dimensions are provided in Table 6. All feature details are mirror imaged on each side. Dimension (E) is the direct distance between the centerlines of the pivot bores and suspension bores. the surface finish specification for the suspension bore and the counterbore face is 3.5 µm (137.79 µinch). The surface finish of the counterbore diameter and all other machined faces is 6.0 µm (236.22 µinch). Both inside faces (Q) are as-cast surfaces and are not matched.
Table 6
OHT Suspension Bore Dimensions mm (inch)    
Model     Support Assy P/N     A     B     C     D     E     F     M     P    
785     5T-2309    
119.05 0.07 mm (4.69 0.003 inch)    
70.19 mm (2.76 inch)    
119.63 mm (4.71 inch)    
189.81 mm (7.47 inch)    
638.38 0.8 mm ( 25.13 0.030 inch)    
131.5 mm (5.18 inch)
minimum    
123.0 0.5 mm (4.84 0.020 inch)    
810.0 1.0 mm (31.89 0.04 inch)    
785B    
785C    
785D    
789     5T-5530    
131.77 0.07 mm (5.19 0.003 inch)    
84.72 mm (3.34 inch)    
127.57 mm (5.02 inch)    
212.28 mm (8.36 inch)    
707.74 0.8 mm ( 27.86 0.03 inch)    
146.5 mm (5.77 inch)
minimum    
130.5 0.5 mm (5.14 0.02 inch)    
806.2 1.0 mm (31.74 0.04 inch)    
789B    
789C    
789D    
793     136-2235    
906.2 1.0 mm (35.68 0.04 inch)
793B    
793C    
793D    
793F    
793F     316-7792    Dimensions apply to Illustration 7. Unless otherwise specified, tolerance is 0.25 mm (0.01 inch).
Illustration 8 g02363037
Stabilizer bore dimensions for 785 through 793C models, mm (inch). The stabilizer bore surface is 3.5 µm (137.79 µinch). The surface finish of the four faces is 6.0 µm (0.23622µinch). The chamfer is the same on both outside faces. Unless otherwise noted, all tolerances are 0.25 mm (0.0010 inch).