PLATE AS 3079476 - Caterpillar

Installation Procedure
Illustration 1 g06021250
(A) 15 mm (0.6 inch) on center
(B) 45 degrees
(C) 6 mm (0.24 inch) on center (x 2)
(D) 33.5 mm (1.32 inch)
Illustration 2 g06021169
(4) 468-4041 Film
Drill the mounting holes for the switch. Refer to Illustration 1.Apply Film (4). Refer to Illustration 2.
Illustration 3 g06021288
Illustration 4 g06021290
Illustration 5 g06021297
Remove two screws that hold the gauge / switch panel cluster in place. Refer to Illustrations 3,4, and 5.
Illustration 6 g06021312
Pull out the gage / switch panel and locate the harness.Harness is tied back to the bottom of the console structure. Locate the harness and cut the wire tie.Secure the harness end to the gage cluster harness. Make sure that you leave enough slack to connect to the switch.Note: On the canopy machine you may remove the cab air filter cover on the RT console to the lower right of the seat. This action may provide some additional access to acquire the harness.
Illustration 7 g06021520
(E) Harness
(3) 466-4647 Rotary Switch As
Connect harness (E) to Rotary Switch As (3). Refer to Illustration 7.
Illustration 8 g06021535
(3) 466-4647 Rotary Switch As
Orient Rotary Switch As (3) with the connector at approximately 11:00. Refer to Illustration 8.
Illustration 9 g06021552
(3) 466-4647 Rotary Switch As
(5) 198-9706 Screw
Rotary Switch As (3) is in position awaiting mounting screws (5). Secure switch with mounting screws. Refer to Illustration 9.
Illustration 10 g06021569
(F) Allen head lock screw
(2) 356-6069 Control Knob
Reinstall the gage / switch panel in position.
Align Control Knob (2) indicator and symbols. Tighten Allen head lock screw (F). Refer to Illustration 10.
Illustration 11 g06021572
Connect ET and set engine configuration parameter for throttle enable status to "Throttle #1 and Throttle #2". Refer to Illustration 11.