PLATE 3095077 - Caterpillar

Illustration 3 g01528067
314D CR pump compartment (9) Pressure tap (drive pump ) (10) Pressure tap (idler pump ) (11) Pressure tap (power shift)
Install a pressure gauge with a 6000 kPa (870 psi) capacity on pressure tap (11) for the power shift.
Install a pressure gauge with a 60000 kPa (8700 psi) capacity on pressure tap (9) for the drive pump and on pressure tap (10) for the idler pump.
Start the engine.
Place the machine controls at the following settings: engine speed dial 10 and AEC switch OFF. Refer to Testing and Adjusting, "Engine Performance - Test (Engine Speed)" for the machine for engine rpm settings.
Warm the hydraulic oil to 50 °C (122 °F).
Set the pilot pressure to the specifications in Testing and Adjusting, "Relief Valve (Pilot) - Test and Adjust" for the machine.
Set the main relief valve to specifications. Refer to Testing and Adjusting, "Relief Valve (Main) - Test and Adjust" for the machine.
Calibrate the solenoid valves. Refer to Testing and Adjusting, "Medium Pressure: Solenoid Valve (Proportional Reducing) - Calibrate (F4 Valve)" for the Tool Control System.
Set the auxiliary tool mode for medium pressure. Refer to Testing and Adjusting, "Work Tool - Select" for the Tool Control System.
Illustration 4 g01197980
(1) Up key (2) Right key (3) Home key (4) Main menu key (5) Left key (6) Down key (7) Cancel key (8) OK key
Use the following procedure to access the "SERVICE" mode of the monitor.
From the default screen, press the main menu key (4) .
Use the right key (2) or the left key (5) in order to scroll through the menu options.
When the "SERVICE" option is highlighted, press the OK key (8) .Note: In order to access the "SERVICE" screen, the password for service must be entered.
When "PASSWORD" screen appears, use the right key (2) and the left key (5) in order to scroll through the characters. When the desired character is highlighted, press the OK key (8) . Enter the password for service FFF2 in order to continue to the "SERVICE" screen.
After the password has been entered the "SERVICE" screen should appear. Refer to Illustration 5.Note: For more detailed steps with entering passwords or entering the service mode, refer to Testing and Adjusting, "Service Mode - Enter" for the Tool Control System.
Illustration 5 g01200022
Typical example of the "SERVICE" menu for the monitor
Use the down key (6) in order to scroll through the menu options.
When the "DEVICE TEST" option is highlighted, press the OK key (8) .
Illustration 6 g01428273
After the OK key is pressed, the "DEVICE TEST" menu should appear.
Use the down key (6) in order to scroll through the menu options.
When the "1 PUMP FLOW LIMIT" option is highlighted, press the OK key (8) .
Use the down key (6) in order to highlight the value of the pump flow.
Use the right key (2) in order to decrease the value of the pump flow. Use the left key (5) in order to increase the value of the pump flow. Adjust the pump flow limitation to 40 L/min (10.5 US gpm).Note: To prevent a change