PLATE AS 3109009 - Caterpillar

Removal Procedure
Start By:
Remove steering wheel.
Illustration 1 g01119509
Remove bolts (3) and plate (2). Relocate floor mat (1).
Illustration 2 g03805502
Illustration 3 g03805511
Remove cover (4). Disconnect harness assemblies (5). Remove cover (6).
Illustration 4 g03805494
Remove cover (7). Separate lower panel (8) at Location (X). Remove lower panel (8).
Illustration 5 g03805517
Illustration 6 g03805580
Illustration 7 g03805587
Remove bolts (9). Remove mat (10). Remove bolt (11).
Illustration 8 g03805595
Lean cover assembly (12) rearward toward the steering column.
Illustration 9 g03805600
Disconnect cable assembly (13) from the latch. Remove nut (14), feed the cable assembly (13) out of the bracket.Note: If hood were to close after removing cable assembly (13) there is no way to release the hood latch.
Illustration 10 g03805610
Illustration 11 g03805636
Raise caps (15) and remove nuts (16). Remove nuts (17).
Illustration 12 g03805642
Disconnect harness assembly (18). Remove front wiper motor (19).Installation Procedure
Install front wiper motor (19) in the reverse order of removal.
Illustration 13 g03805694
Illustration 14 g03805675
Tighten nuts (17) to a torque of 15 N m (133 lb in).
Tighten wiper arm nut (16A) to a torque of 24 N m (212 lb in), allow to relax for 30 minutes. Retorque to a torque if 24 N m (212 lb in).
Tighten wiper arm nut (16B) to a torque of 40 5 N m (30 4 lb ft), allow to relax for 30 minutes. Retorque to a torque of 40 5 N m (30 4 lb ft).