PLATE-MOUNTING 3110508 - Caterpillar

Removal Procedure
Start By:
Tilt the cab. Refer to Disassembly and Assembly, "Cab - Raise" for the machine that is being serviced.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g00750914
Remove bolt (1), the washer, and the clip.
Remove bolt (4), the washer, and the spacer.
Remove bolt (2), the washer, and the clamp.
Remove bolt (3), the washer, and the clip.
Illustration 2 g00750915
Remove four bolts (5) and the washers.
Disconnect hose (6) .
Illustration 3 g00750916
Remove bolt (8) and the washer.
Disconnect electrical connector (7) .
Remove bolt (9) and the washer.
Illustration 4 g00750917
Remove 16 bolts (10) .
Remove cover (11) .
Illustration 5 g00750857
Disconnect electrical connector (12) .
Remove two bolts (13) and modulating solenoid valve (14) .